ARMOUR PEDALSTATION JNR User manual

PEDALSTATION JNR
USER MANUAL

When using any electronic product basic precautions should always be followed,
including the following:
1. Read all the safety and installation instructions, explanations of graphic symbols
and set-up/controls before using any product.
2. This product must be earthed if using a power supply. In the unlikely event of malfunction
or breakdown, grounding provides a path of least resistance for an electric current,
which reduces the risk of electric shock.
DANGER: Improper connection of the equipment grounding conductor can result in a
risk of electric shock. Check with a qualied electrician or service professional if you are
in doubt as to whether the product is properly grounded. Do not modify the plug provided
with the product. If the plug does not t the outlet, have a proper outlet installed by a
qualied technician.
3. To reduce the risk of injury, close supervision is necessary when the amplier is used,
especially near children.
4. Do not use this product near water: eg. near a bathtub, sink, in a wet basement,
near a swimming pool.
5. This product may be capable of producing sound levels that could cause permanent
hearing loss. Do not operate for a long period of time at a high volume level, or at a level
that is uncomfortable.
6. Never use or store the unit in places that are subject to temperature extremes, damp,
exposed to rain, dusty or are subject to high levels of vibration.
7. This product should be located away from heat sources, such as radiators, heat registers,
or other products or circumstances that produce heat.
8. This product should be connected to a power supply only of the type described in the
operating instructions or as marked on the product.
9. Care should be taken so that objects do not fall and liquids are not spilled onto the
amplier through any openings.
10. The product should be serviced by qualied service personnel when:
A. The power supply cord, or the plug, has been damaged.
B: Objects have fallen on, or liquid has been spilled into, the product.
C: The product has been exposed to rain or moisture.
D: The product has been dropped or the components damaged.
E: The product does not appear to be operating normally, or exhibits a marked
change in performance.
INFORMATION FOR YOUR SAFETY

11. Do not attempt to service the product beyond that described in the manual instruction
All other servicing should be referred to qualied service personnel.
12. Do not place objects on the product, the power cord, or place it in a position where
anyone could trip over, walk on, or roll anything over it. Do not allow any part of the
product to rest on, or be installed over, power cords of any type. Improper installations
of this type create the possibility of re and a general safety hazard.
13. For everyday cleaning wipe the unit with a soft, dry cloth. Do not use benzine, thinners,
alcohol or solvents of any kind, to avoid the possibility of discolouration and deformation.
14. The power supply cord of the product should be unplugged from the outlet when left
unused for a long period of time. When unplugging the power supply cord, do not pull
on the cord but grasp it by the plug.
INFORMATION FOR YOUR SAFETY
See the full range at:
WWW.ARMOUR-PRO.COM
IMPORTANT NOTE: To reduce the risk related to the correct and normal use of the
product, all Armour products are accurately tested in a safety laboratory. Do not modify
the present unit, the safety standard and the instrument’s performance could be
compromised, and as a further consequence the warranty will be revoked.

PEDALSTATION JNR
USER MANUAL
INDEX
Parts ..................................................................................................................................................................1
Specications ............................................................................................................................................... 2
Assembling the Pedalstation.................................................................................................................3

PEDALSTATION JNR
USER MANUAL
PARTS
The Armour Pedalstation JNR is designed with the ability to use it as either a
simple 4-pedal board, or as an extended 8-pedal board.
The Pedalstation has 5 parts:
Faceplate A, Faceplate B,
Connector C, Side Connector D
and Power Supply Holder E.
1 pcs of Faceplate A
1 pcs of Faceplate B
2 pcs of Connector C
2 pcs of Side Connector D
1 pcs of Power Supply Holder E
NOTE:
3 pairs of adhesive backed hook-and-loop
for securing pedals are also included
Faceplate A
Faceplate B
Connector C
Connector D
Power Supply Holder
See the full range at:
WWW.ARMOUR-PRO.COM

PEDALSTATION JNR
USER MANUAL
SPECIFICATIONS
PEDALBOARD
Material
Hardened aluminium
Finishing
Powder coated, wear-resisting
and scratch-resisting process.
Dimensions
35*28*4.5 / 1.5 cm
Weight
1.14kgs
SOFT BAG
Dimensions
38*30*11cm
Weight
0.58kgs

PEDALSTATION JNR
USER MANUAL
ASSEMBLING THE PEDALSTATION
There are 5 steps to assemble the Pedalstation.
Step 1 Place Faceplate A and B together.
Step 2 Connect these two faceplates with the Connect C.
Step 3 Place the three parts in a horizontal line.
Step 4 Screw the Side Connector D with a wrench tool.
Step 5 Screw the Power Supply Holder E with a wrench tool.
NOTES:
1. Please put the power supply inside the Holder before installing
the Holder. The backside of the Holder will catch the power
supply, keeping it sturdy.
2. To use as a 4 Pedal board, use the smaller plate to assemble
on the sides, and the extra supplied middle stabilising leg.
Please see the below assembly diagrams:
Special Note:
POWER SUPPLY USE:
Put the power supply
inside the Holder before
assembling the Holder.
Make the outputs of the
power supply are facing
outward.
STEP 1
STEP 4
STEP 2
STEP 5
STEP 3
STEP 6
See the full range at:
WWW.ARMOUR-PRO.COM

IT GETS THE
JOB DONE