Ascend C156 User manual

CANOE OWNER’S MANUAL
Manufactured by KL Industries, Muskegon, MI 49444 www.sundolphin.com

2BASS PRO | ASCENDTM CANOE OWNER’S MANUAL
Congratulations on the recent purchase of your new Ascend canoe!
You have purchased a canoe from one of the nation’s leading manufacturers of small boats.
Your canoe represents years of commitment to product design, excellence in engineering
and quality in manufacturing. With proper care and maintenance your canoe should last
for many years to come. Please call our helpful and knowledgeable Customer Support
Department if you have any questions or concerns.
MATERIALS
Your canoe is manufactured from High Density Polyethylene (HDPE). It is a very durable material. Our specially formulated HDPE has an
ultra-violet inhibitor blended throughout the material to reduce color fade and maintain its strength. Polyethylene is a somewhat flexible
material with some memory. This means it has a tendency to return to its original molded shape if distorted.
BOAT SET-UP
Recommended Motor & Battery
Square Stern models come equipped with a built-in motor transom designed for an electric trolling motor.
Maximum motor size: 40 lb. thrust standard shaft length.
Many trolling motors come with “alligator clips” or “ring connectors” for direct connection to a battery.
Recommended battery: 12 Volt DC.
NOTE: Be sure to connect the same color wires together. The RED wire on the plus is positive (+) and the BLACK wire is negative (-).
Consult the trolling motor instructions for more details or call Customer Service.
Important: Motors should always be removed when transporting or storing.
Battery Location
The battery may be placed either between the back seat and the stern of the boat or behind the center seat. It is recommended
securing the battery to the boat with a strap.

3
Paperwork
The following documents should come with your new canoe.
Warranty Registration Card
To properly register your boat with KL Industries for warranty validation please fill out the warranty registration form online at www.sundolphin.com.
Please review our full warranty statement. If you are unable to register your boat online please contact our Customer Support Department at 231-733-2725.
The serial number can be found on the outside of the hull in the back just under the gunwale. See Photo #1.
Manufacturer’s Statement of Origin (MSO)
Some states may require an MSO for proper registration of your canoe. Please check with your local dealer or state licensing bureau.
Owner’s Manual
Keep your owner’s manual for future reference. It is a good idea to write down the following information:
Serial Number
Date of Purchase
Purchased from
Applying Decals
Before applying boat registration decals (if required), clean the area with alcohol or any solvent that does not leave a residue. Make sure solvent is put aside
and is dry. Using a propane torch, lightly pass the flame back and forth over the area where the decals will be applied. Don’t try to heat the surface.
This process will enhance the adhesion of the decals.
Serial Number
Location

4BASS PRO | ASCENDTM CANOE OWNER’S MANUAL
BEFORE LEAVING SHORE & SAFETY PROCEDURES
• It is recommended to keep paddles onboard even if you are using a motor.
• Make sure the battery weight is distributed evenly onboard.
• Check the weather conditions, especially wave conditions in open water. Anticipate changing weather conditions and act accordingly.
• Review the maximum capacities on the capacity plate. Ensure you are safely within these limits.
• Make sure all passengers are wearing Personal Flotation Devices.
• Take an extra paddle.
• Let someone know where you are going and when you will return.
CARE AND MAINTENANCE
With minimal care and maintenance, your boat has been designed to provide you with many years of enjoyment.
• Your canoe can be cleaned with warm water and any standard detergents. More difficult stains, such as brackish watermarks, may be cleaned with a
petroleum based cleaner. Read the manufacturers’ instructions carefully before using any cleaner.
• Periodically check the integrity of all fasteners to ensure proper use.
• Polyethylene is a somewhat flexible material with some memory. This means it has a tendency to return to its original molded shape if distorted. If this
occurs follow these steps:
1. Relieve the pressure that caused the dent or distortion by supporting the boat differently or removing gear.
2. Place the boat in the warm sun. Usually the south side of a building is the warmest spot. As the boat warms up usually (but not always)
the boat will return to its original molded shape. This may take a few hours or a couple of weeks depending upon outside temperatures and
the degree of distortion.

5
STORAGE
• If possible, it is best to store your canoe inside for the winter, otherwise store upside down. Do not store the canoe on sawhorses right side up.
If canoe must be stored upside down, position the supports about 1/3 of the way in from each end. Do not pile gear on top of the canoe.
• Motors should always be removed when storing.
WARRANTY
Please call us at 231-733-2725 if you have questions or a problem with your boat. Do not return the boat to the retailer.
KL Industries Inc. warrants to the original owner of any KL Industries boat. Any part of the boat that is defective in material or workmanship will be repaired,
without charge, at the purchaser’s local dealer or at KL Industries.
For personal use, this warranty shall apply for a period of two years on the deck and hull and two years on parts from the date of retail sale. Any warranties
from suppliers of component parts supersede KL Industries’ warranty. This warranty covers use under normal conditions and does not cover damage caused
by accidents, alteration, or misuse.
Freight to and from a local dealer or manufacturing plant is at the owner’s expense.
Warranty is not valid unless registration card is returned within 30 days of retail purchase.
Register online at www.sundolphin.com

6BASS PRO | ASCENDTM CANOE OWNER’S MANUAL
DIMENSIONSFEATURES
AscendTM C14
14’ Recreational Canoe
Length 14’ 427 cm
Width 38” 97 cm
Height 15 1/2” 39 cm
*Weight 84 lbs 38 kg
Capacity 765 lbs 347 kg
* Canoe only. Excludes accessories.
1Comfortable Molded Seats Aid in Flotation 2
Rugged UV‑stabilized Fortiflex
®
High Density Polyethylene Hull
3Storage Compartment 4Locking Paddle Holders
5Beverage Holders 6Built‑in Transport Handles
7Built‑in Keel for Superior Tracking 8Center Seat Includes Built‑in Cooler
9Bow & Stern Tie Down Eyelets 10 Fishing Rod Holders
11 Protective Rubrail
1
2
5
5
3
8
10
11
10
9
9
6
6
7
4

7
Length 15’ 6” 472 cm
Width 42” 107 cm
Height 18 1/2” 47 cm
*Weight 99 lbs 45 kg
Capacity 800 lbs 363 kg
DIMENSIONSFEATURES
* Canoe only. Excludes accessories.
AscendTM C156
15’ 6” Square Stern Canoe
11
1Comfortable Seats with Back Support 2
Rugged UV‑stabilized Fortiflex
®
High Density Polyethylene Hull
3Storage Compartment 4Locking Paddle Holders
5Beverage Holders 6Built‑in Transport Handles
7Built‑in Keel for Superior Tracking 8Center Seat Includes Built‑in Cooler
9Tie Down Eyelet 10 Fishing Rod Holders
11 Protective Rubrail 12 Sturdy Square Back Transom
1
2
5
10
5
3
8
9
12
6
6
7
10
4

8BASS PRO | ASCENDTM CANOE OWNER’S MANUAL
Rev.1 11/2013