It is always recommended to anchor the unit to the ground. Drill through
the four holes in the base rails of the unit using 6mm dia masonry drill to
a depth of 70mm. Screw in the anchor fixings. (These have a self cutting
thread). Additional ZHWNUT42 and ZSCREW254 have been supplied for
bolting 2 units together using the side panels.
TOOLS REQUIRED
Power driver POSI-DRIV screwdriver, 6mm dia. masonry drill and a
10mm socket or spanner.
TWIN BIKE SHELTER
BASE INSTRUCTIONS
Flat and firm base. Recommended: concrete, tarmac or paving flags.
Min. distance from walls/ shrubbery: 1000mm.
Min. base size (WxDxH) 1000mm x 2000mm x 50mm.
LEVELING THE UNIT
Correctly level the constructed unit using the shims (ZCOMPPLAS)
provided prior to fixing the unit to the ground. Slide the packing pieces
under the corners of the unit base as required until an equal gap has
been achieved around the door allowing for its smooth operation and
alignment.
Warning: some panels may weigh over
20Kg. Beware of manual handling
www.asgardsss.co.uk
044540/29.06.21/KW/R5
10mm
Spanner
4mm
Allen Key
18V
For maintenance instructions of this product visit www.asgardsss.co.uk
x2
SEALANT
ZSCREW32 x6
ZSILCO1 x1
ZSCREW100 x68
ZSCREW254 x4
ZCOMPPLZS02 x8
ZCOMPPLAS22-23-24 x6
2x 2mm, 2x 3mm, 2x 5mm
FIXING CHANNEL 42655 x2
SIDE PANEL 42172 x1
BACK PANEL 42171 x1
DOOR FRAME x1
LEFT HANDED: 43802 OR
RIGHT HANDED: 43801
LEFT HANDED SHOWN
TOP STIFFENER 42397 x1
(Please note, this is found in the
top roof section when delivered)
SIDE PANEL 42172 x1
6mm
Dia.
Posi-Driv
Screwdriver
ZHWNUT42 x4
35190 x2
TOP PANEL 42170 x1
