dux.com DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.
Printed 2021.02.01
1
HARDWARE TOOLS NEEDED
2 Male
bracket* 2 Short bolt*
1 Remote control**
1 Control unit**
2 Long bolt*
2 Nut*
* for queen and king size
** for queen and king size
2 Female
bracket*
2 Washer*
Spanner mm
or adjustable
wrench
(not included)
Screwdriver flat
(not included)
ASSEMBLING
I. FASTEN FEMALE BRACKET-BED
Fasten female brackets to the bed.
Locate the pre-drilled holes at the head of
the bed and pull out the plastic
bolt. Bolt the female brackets through the
pre-drilled holes and place a washer
then nut on the bolt under the bed.
Make sure that the brackets are straight
up and down with the narrow
end at the bottom, then wrench tighten.
II. FASTEN MALE BRACKETS - HEADBOARD
AMake sure that the ttings are in the right
position for you bed.
For adapting >120 cm wide beds, place
the ttings in the hole market 1.
For <140 cm wide beds, move the ttings
to hole 2.
BMake sure that the brackets are
straight up and down with the narrow end
at the bottom, then wrench tighten.
1
2
1
2
