Asset construction hire Atlas Copco P6500 User manual

PORTABLE GENERATOR
SAFETY SHEET
(Atlas Copco P6500)
PLEASE READ THIS GUIDE CAREFULLY BEFORE
OPERATING THE EQUIPMENT
IMPORTANT - CONDUCT A RISK ASSESSMENT
Before you commence any work at your chosen work area, you should
undertake some preliminary hazard identication and risk control
precautions. Ideally more than one person should do this.
This is undertaken by:
1. Physically inspecting the work site
2. Reviewing the best way/job steps required to complete the task
3. Reviewing the Safe Work Information supplied with the equipment
4. Reviewing other reference documentation and expert advice.
The hazard identication and control process steps are dened as:
1. Identify the Hazards (eg. 240V power drill use around wet areas)
2. Assess the Risk (multi earth paths - possible electrocution)
3. Select the Control Measure (e.g. dry the area; use an RCD; use a
cordless drill etc)
4. Re-assess the Risk (risk of electrocution now negligible). This is
undertaken to ensure that the risk control measures adopted have not
introduced any new risks to the work area.
HELP AND SUPPORT
If the unit does not operate correctly or you are unhappy with its
performance, return it to Asset Construction Hire for an exchange,
or phone for assistance. Do not attempt repairs yourself.
Asset Construction Hire
Phone:[phone] or email: o󰀩[email protected]
OPERATION MANUAL
A PDF of the full Operation Manual is available at:
www.assethire.com.au/manuals-specs-safety-sheets/
and must be read before using the equipment.
BEFORE OPERATING THE EQUIPMENT:
• Read this Safety Sheet and any other information provided with the
equipment, including instructions, decals and operation guidelines.
• Check that you understand how and when the use the equipment,
and know how to operate it safely.
• Ensure that it is only used according to the manufacturers and hirer’s
instructions, and only for work that is compatable with its technical
limitations.
• Operate in a clear work area free from nonessential persons, children,
animals or hazards.
• Ensure that you have a secure footing and clear access and egress to
the work area while on the job.
• Do not operate any equipment if you are tired or su󰀨ering any medical
condition, or if under the inuence of drugs or alcohol which may
cause lethargy or dangers to yourself or others.
• Do not use faulty equipment. If in doubt contact Asset Construction Hire.
PERSONAL PROTECTION
EQUIPMENT (PPE)
PROTECTIVE
GLOVES
HEARING
PROTECTION
SAFETY INFORMATION
Do not use the equipment indoors.
• Keep the unit clean and avoid spilling any combustibles such as
gasoline on the equipment.
• Do not operate near water or moisture.
• Do not connect to a home power system.
• Unit must be safely grounded.
• The surface of the generator set becomes extremely hot. To avoid
serious burns, pay attention to the warnings.
• The generator produces enough electric power to cause a serious
shock or electrocution if misused.
• It is prohibited to use bare wire to connect power supply to the electric
equipment directly, use the plug that ts local regulations.
• When the unit is operating, do not touch wire or live parts of the
equipment. Never touch the machine with wet hands or electrical
shock will occur.
• When the unit is operating, keep children at a safe distance from the
generator. When the unit is operating, strictly prohibit the assembling
and disassembling of any parts.
• It is recommended to make a tandem connection of a ground fault
circuit interrupter (GFCI) when the power supply is out, in order to
ensure safety.
• External electric accessory (including cable and plug interconnecting
piece) shall have no faults. Electric shock protection depends on the
circuit breaker, especially the matching between the breaker and
generator set. When replacing the breaker, use only a replacement
with the same rating and performance features. Contact a local dealer
or the after-sales service center for support.
• In case of using length ening wire or mobile power distribution cabinet,
overall length of the wire with a cross section of 1.5mm2shall be no
longer than 60m, and 2.5mm2wire shall be no longer than 100m.
• Avoid connecting the generator in parallel with any other generator.
• The generator fuel is ammable, generating high temperatures, and
can easily cause re.
• It is strictly prohibited to add fuel while the equipment
is operating.
• In case of adding fuel, keep far away from re sources, and do not
allow smoking any where near the unit.
• When adding fuel, do not spill fuel on the equipment.
• In case of accidental spills, use cotton cloth to clean it. Start the
equipment only after spilled fuel is completely evaporated.
• When operating, make sure there is no ammable substance within
a 2-meter range, and no ammable substance should come near the
equipment. Avoid placing any ammable materials near the exhaust
outlet while operating.
• In case of long-term nonuse, drain the fuel from fuel tank and store it
safely. If you swallow any fuel, inhale fuel vapor, or allow any to get in
your eyes, see your doctor immediately. If any fuel spills on your skin
or clothing, immediately wash with soap and water and change _your
clothes.When operating or transporting the machine, be sure It Is kept
upright. If it tilts, fuel may leak from the carburetor or fuel tank.
• Do not throw the residue fuel or used motor oil into the trash or pour it
onto the ground. We suggest you take used oil in a sealed container to
your local recycling center or service station for reclamation.
This equipment contains high-speed revolving parts, which can cause
bodily injury
• When operating the equipment, do not approach the unit or touch any
revolving parts.
• Do not lift or move the equipment while operating. Move it only after
equipment has completely stopped.
• When operating the equipment, observe surroundings. Make sure no
articles are introduced into the equipment.

PORTABLE GENERATOR
BASIC INSTRUCTIONS
(Atlas Copco P6500)
GROUNDING THE UNIT
• Place the unit outdoors, use wire of no less than 2.5mm2to connect
the unit and grounding terminal to the ground. One end of the
wire is pressed below the buttery nut of the unit, screwed up tightly,
and the other end is connected to the metal rod-shaped piece (such as
the iron nail and the opener), and inserted into soil.
FILLING OIL
• Remove the oil ller cap, ll with the proper type of oil. Use the funnel
for lling. If any spills occur, clean the ground thoroughly to avoid
slipping.
REFUELING
• Open the fuel tank cap and ll tank with gasoline . The fuel gauge will
display the level of gas in the fuel tank. Caution: the maximum fuel
level must not exceed the inner strainer of the tank when lling.
SHUTTING DOWN THE UNIT
STARTING THE UNIT
1
2
3
4
5
6
7