Atdec AWM-W35 User manual

AWM-W35 Page 1 of 2
Installation Guide
AWM-W35
Wall Channel
COMPONENT CHECKLIST
REQUIRED TOOLS
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! This product is compatible with Atdec modular (AWM) products.
! The manufacturer accepts no responsibility for incorrect installation.
A
Wall channel
(x1)
E
Nylon
Anchor (x3)
C
Top Cap
Screws
(x2)
B
Top Cap
(x1)
D
M6 x 50mm
Countersunk
Screw (x3)
• Power Drill
• 4mm (5/
32”) Drill Bit
• 8mm (5/
16”) Drill Bit
• Phillips Head Screwdriver

AWM-W35 Page 2 of 2
3. Install top cap 4. Cable clips
4.1 Push the cable down into the Cable Clip.
4.2 Insert one side of the
Cable Clip into the Channel
on the Post assembly
or Wall Channel, before
pushing the other side in.
3.1 Attach Top Cap
Phillips Head
Screwdriver
Top Cap
1.1 Masonry 1.2 Timber stud
1. Install Wall Channel - Ensure all fasterners are installed
atdec.com | atdec.co.uk | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20190129A
Note: Cable clips
sold separately in
packs of four.
8mm (5/
16”) holes
4mm (5/
32”) holes
Stud
Nylon anchors
M6 x 50mm
Screws M6 x 50mm
Screws
2. Fit channel clamp to wall channel
2.1 Ensure knob is undone. 2.2 Slide clamp into channel.
Push knob to
aid insertion
2.3 Hold clamp in desired position on post
and turn knob to lock in place.
1. Ensure Knob is undone
Tip: push knob
to aid insertion
2. Slide clamp into channel
3. Hold clamp in desired position on post and turn
knob to lock in place