Atdec Th-2050-vfm User manual

Components Checklist

TOOLS REQUIRED:















Hardware





























Mounting Screws

















IMPORTANT INFORMATION

 





 





! IMPORTANT - Install Wall Mount as per Installation Instructions.



      

      

  



Step 1. Check Components



Step 2. Locate Drilling Position







































Top

Step 3. Attaching the Articulated Arm to the Wall

Timber Stud Wall









Masonry Wall



















Wall

















Installation Instructions

Flat Screen Wall Mount / Full Motion

TH-2050-VFM

Only use the Extension Plates if the Display you wish to mount has a VESA hole configuration:

400x200mm, 400x300mm, 400x400mm. If not, skip to Step 5. A

TIGHTEN

FIRMLY

Dome Nut

Extension Plate

VESA Plate

Star Washer

Top of

Display

Spacer Bush (x4) optional

used for recessed mounting

holes or curved panels.

Choose appropriate Mouting Screws and Washers

from the Hardware supplied to suit your Display.

Mounting Screw (x4) Washer (x4)

VESA plate

Mounting

Hole

IMPORTANT:

Using the 4mm Allen Key

loosen (do not remove)

the Security Screw until flush

with the Quick-release Hook.

Slide the VESA plate onto

the Quick-release Hook.

VESA plate

LOOSEN

TIGHTEN

Rotate the Display into a

Horizontal position as

required.

Back of Display

+/- 5°

Security

Screw

(FLUSH)

Quick-release

Hook

Step 4. Fasten Extension Plates to the VESA Plate (optional)

400x400mm

Step 6. Attaching your Display to the Articulated Arm

Tighten the Security

Screw fully to lock.

Step 5. Attaching the VESA Plate to your Display

Step 7. Cable Management

Remove Cable Covers using a Phillips Head Screwdriver, and route the cables

along the length of the arms. Reattach the Cable Covers to hold the Cables in place.

Cable Covers

Clamp

Lever

Tighten the Clamp Lever to lock

the Display in desired position.

TILT DOWN

TILT UP

TIP: Leave enough slack in the cables

to allow full movement at the joints.

Cable Covers

Step 8. Tilt Adjustment

Installation Complete

400x200mm

400x300mm

OR OR

Connect cables to your Display and route through Cable Clips.

As TFT Manufacturers are constantly releasing new monitor models, Atdec does not accept responsibility if the VESA mounting does not comply with the international standards.