Atdec AWM-W6 User manual

AWM-W6 Page 1 of 2
A
Wall channel
(x1)
E
Nylon
Anchor (x2)
C
Top Cap
Screws
(x2)
B
Top Cap
(x1)
D
M6 x 50mm
Countersunk
Screw (x2)
IMPORTANT INFORMATION
!Please ensure this product is installed as per these installation instructions.
! The manufacturer accepts no responsibility for incorrect installation.
!This product is not suitable for outdoor use.
!Do no use this product for mobile application.
!Wall Bracket only achieves maximum weight rating when appropriately fastened to a wall of adequate structural capacity.
!Professional installer to ensure adequate structural capacity of wall (including appropriate safety factor) to support total
weight of all equipment being mounted.
!Drilling into electrical wires can cause death - use appropriate equipment and caution when drilling holes in walls to avoid
electrical cables, water pipes and gas pipes. Do not drill into structures unless you have established it’s safe to do so.
!This product is only compatible with AWM Series products, including: AWM-A13, AWM-A46, AWM-A71 and AWM-ADC.
!This product is not compatible with the AWM Heavy Duty Heads, including: AWM-LTH and AWM-LR.
REQUIRED TOOLS
• Power drill
• Suitable drill bit
• Driver bit for selected
wall fasteners
• Stud nder
• Spirit level
WEIGHT RANGE
0 - 12kg
(0 - 26.5lb)
Monitor weight should be within
the weight range of all modular
elements that make up the complete
monitor mounting solution.
Installation Guide
AWM-W6
Wall Channel
COMPONENT CHECKLIST

AWM-W6 Page 2 of 2
2. Fit channel clamp to Wall Channel
3. Fit Top Cap to Wall Channel
Phillips Head
Screwdriver
Top Cap
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specications without notice. ©20221028
2.1 Ensure knob is undone. 2.2 Slide clamp into channel. 2.3 Hold clamp in desired position on
post and turn knob to lock in place.
1. Ensure Knob is undone
Push knob to
aid insertion
Tip: push knob
to aid insertion
2. Slide clamp into channel
3. Hold clamp in desired position on post and turn
knob to lock in place
1. Mount the Wall Bracket to the Wall
OPTION 1: Masonry OPTION 2: Timber stud
8mm (5/
16”) holes
Nylon anchors
M6 x 50mm
Screws
4mm (5/
32”) holes
M6 x 50mm
Screws
Using the Wall
Channel as
a template,
mark the
two xing
hole positions
for drilling.
NOTE: On a Stud
Wall, use a good
quality Stud Finder
to position mounting
fasteners in the
centre of studs.
NOTE: Wall Channel
must be level. Verify
using a quality spirit
level tool positioned
along the side edge
of the wall channel.
OR
x2