AtGames LEGENDS CONNECT User manual

More Games to Play
Discounts and Special Offers for Members
Online Multiplayer and Voice Chat
Global Leaderboards and Leagues Events Sign Up at www.arcadenet.net
Sign Up For ArcadeNet®!
INSTRUCTION Manual
about Legends Connect
Package Includes
The AtGames Legends Connect is The Ultimate Single Board Arcade Solution™,
providing everything you need to power your home arcade projects. Simply install the
Legends Connect mainboard inside your project to enjoy 20 licensed arcade and
console games, as well as gain access to all of the amazing Legends Arcade Platform
features. The Legends Connect is ready to power your full-size, scale, cocktail,
countertop, console, virtual pinball, or any other type of home arcade project you can
imagine!
Legends Connect Features
A. 40 PIN CONNECTOR
B. POWER CONTROL connector
1. Legends Connect Board x1
2. Spacer x4
3. Antenna x1
4. Instruction Manual x1
5. Jumper Cap x1
QUICK START GUIDE
All screenshots shown are for illustration purposes only. Actual screens may vary.
Power on the device.1.
Use P1 controller to select from [GAMES]
to enjoy 20 pre-loaded games. (Note:
Internet connection is not required. The
games can be played offline.)
2.
To access the internet, connect an Ethernet
Cable (not included) or go to [SETTINGS]
to connect through Wi-Fi.
3.
To connect through Wi-Fi:
4-1. Select [Wi-Fi] under the [SETTINGS]
page.
4-2. Select the Wi-Fi SSID you would like to
connect to, and select [Connect]. If
prompted, enter the Wi-Fi password using
the on-screen keyboard and select [Submit]
when done.
4.
12V POWER INPUT
POWER CONTROL CONNECTOR
HDMI OUTPUT
ETHERNET
LED CONNECTOR
REAL-TIME
CLOCK BATTERY
(CR2032)
SPEAKER/AMPLIFIER
CONTROL SWITCH*
40 PIN CONNECTOR
WIFI ANTENNA
CONNECTOR
RECOVERY
USB (up to 480 Mbps)
USB (up to 5 Gbps)
5V 1 2 3.3V
N/C 3 4 N/C
N/C 5 6 HOME
N/C 7 8 N/C
N/C 9 10 N/C
P2-C 11 12 P1-C
P2-B 13 14 P1-B
P2-Z 15 16 P1-Z
P2-Y 17 18 P1-Y
P2-X 19 20 P1-X
P2-A 21 22 P1-A
P2-RIGHT 23 24 P1-RIGHT
P2-LEFT 25 26 P1-LEFT
P2-DOWN 27 28 P1-DOWN
P2-UP 29 30 P1-UP
P2-START 31 32 P1-START
REWIND 33 34 N/C
GND 35 36 GND
VOL + 37 38 VOL -
N/C 39 40 N/C
1 2
LED 1
DC INPUT 2
NC 3
POWER SWITCH 4
DC INPUT 5
GND 6
1
C. LED CONNECTOR
NC 1
GND 2
NC 3
5V 4
3.3V 5
1
*Please refer to the Application Note - AN-101: Pandora's Box Compatibility.

PO Box 1691, El Segundo, CA 90245
All rights reserved.
www.atgames.net
© 2020 AtGames Interactive
*Content and images are for reference only and subject to change.
For technical support please email:
[email protected]
Made in China
Legends Connect™ is a trademark of AtGames Cloud Holdings Ltd.
All other company and product names may be trademarks of their respective owners.
HOW TO UPDATE FIRMWARE
1.
2.
3.
4.
5.
Power on the device.
Connect internet via Ethernet (Ethernet cable is not included) or Wi-Fi.
Go to [SETTINGS] and select [Version].
If there is a newer version, follow the instructions to download the latest firmware.
Make sure the internet connection is stable during this process.
Once the firmware is downloaded successfully, select [Upgrade] and the device will
reboot automatically to activate the new firmware version.
Note: If you encounter any issues on firmware update, please contact [email protected]
How to Sign in with your Legends account
The manufacturer warrants this product to be free and clear of defects in the materials and workmanship, under
normal residential use and conditions, for a period of thirty (30) days from the original invoice date. Shipping and
handling fees are to be paid for by the customer. To make a warranty claim, please submit a service request here:
[email protected].
Standard warranty coverage for the AtGames Legends Connect does not apply to and is considered invalid due
to misuse, improper maintenance, self-repair, tampering, or invasive hardware modifications of any kind, and
damages or dysfunction caused by shipping or non-manufacturing related causes.
Note: Standard warranty services are valid with receipt from an authorized retailer. Purchases through
third-party sellers and resellers do not fall under the standard warranty program. For warranty support, please
contact the third-party seller or reseller where you purchased the product.
WARRANTY INFO
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and your body
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Safety Notice
•
•
•
Do not submerge the device in water or expose it to extreme heat or to strong magnetic fields.
Doing so may cause permanent damage to your device.
Always use a dry towel to clean the device.
Transformers are suitable for indoor use only. Transformers and power supplies for toys are not intended to
be used as toys, and the use of these products by children shall be under the full supervision of parents.
Game LIST
Andro Dunos
Bang Bead
Battle Flip Shot
Breakers
Breaker's Revenge
Captain Tomaday
Cowboy Kid
Drift Out
Drift Out '94 - The Hard Order
Earth Joker - U.N. Defense Force
Galmedes
Ganryu
Goal! Goal! Goal!
Looping
Mega Twins / Chiki Chiki Boys
Neo Drift Out: New Technology
Panic Road
Storm Blade
Super Tank
The Adventures of Robby Roto
© 2020 PixelHeart. All rights reserved.
Game list is for reference only and subject to change.
The trademarks and images are the properties of their respective owners.
Go to [SETTINGS] and select [SIGN IN].1.
6.
2.Sign up for a new account if you don’t have one yet.
3.Once you have a Legends account, you can choose either to sign in with your Legends ID
or with the QR Code. To sign in with your email, enter the email address and password.
4.To sign in with the QR Code, a smartphone is required.
5.Use a smartphone to scan the QR Code on the screen to launch the ArcadeNet®
website. You will be directed to the login page, where you can choose either to sign in
with your existing Google/Facebook account or your e-mail.
You will see the authorization notification once complete. Now you can close the
window and return to your device.
A “Success!” message will show on the screen once signed in.
6.