Atmor Platinum User manual

Platinum Digital Assembly Instructions
1
Step 1
Step 2
Open the cover and release the 2
digital display quick connectors

Platinum Digital Assembly Instructions
2
Step 3
Open the entrance cable in the
back of the unit.
Be sure to open the side
of the cable
Step 4
Find the optimal place for all
users and stick the drilling hole
template to the wall.
Drill 4 holes and insert Plugs.

Platinum Digital Assembly Instructions
3
Step 5
Hang the unit on the wall by 4
screws
Step 6
Connect a reinforced hose to the
inlet on the left side of the unit.
(Don't forget to insert rubbers).
Be sure to close it well - No need
for tools.

Platinum Digital Assembly Instructions
4
Step 7
Connect the second end of inlet
reinforced hose to the water
supply (don't forget to insert the
rubbers).
Step 8
Connect the outlet hose to the
outlet water connector. (on the
right side).
and the Shower hand to the
second end. (don't forget to
insert the rubbers)
Warranty: Don't connect any tap
to the outlet.

Platinum Digital Assembly Instructions
5
Step 9
1. Insert the Soap dishes.
2. Insert the hand shower holder.
3. Place the ends of the sliding bar.
4. Place the sliding bar on the wall
on right height. (Comfortable height
for all the users in the house)
5. Sign the 4 holes.
Step 10
1. Drilling 4 holes - 2 on top and
2 on the bottom.
2. Insert plugs
Insert the soap
dishes.
Insert the Shower
hand holder.
Remove the cover
ends
Insert the 2 ends
to the bar ends

Platinum Digital Assembly Instructions
6
Step 11
Connect the sliding bar to the
wall using 4 screws
Step 12
Connect the cover of the Sliding
bar ends.

Platinum Digital Assembly Instructions
7
Step 13
Hang the shower hand on the
sliding bar holder.
Step 14
Open the water supply and the
temperature knob (the left knob)
and check for leakage.
If there is no leakage - Go on
If there is leakage,
Find the leakage point
and xe it.
Check again
Don't continue anless you sure
there is no leakage.

Platinum Digital Assembly Instructions
8
Step 15
Insert the Electric cable threw
the holes on the back of the unit.
Step 16
Connect the electric cable to the
Terminal block.
LMN

Platinum Digital Assembly Instructions
9
Step 17
Connect the 2 quick connectors
of the Digital display.
Step 18
Round the Knobs according to
the Facet and Rotering switch
Pivot.
Than put the cover of the unit
Be careful on the digital display
wires.

Platinum Digital Assembly Instructions
10
Step 19
Close the cover by 4 short screws

Platinum Digital Assembly Instructions
11
Step 20
Final view