ATV BSS7550 User manual

1.0
BSS7212 / BSS7550
IR Bullet Cameras

480K(NTSC) pixels.
Main Body
Camera Lens
IR LED
1
4
4
4
4Hex Tool
Bracket
1.0
High resolution SONY Super HAD CCD II camera with 700TVL
module.
External adjust varifocal Lens.
BSS7212 / BSS7550
IR Bullet Cameras

*Wall
Installation
*Ceiling
Installation
1). If cable is preferred to go through walls, loosen the bracket base
screws, take away the bracket plate, the cable through the center
hole of the bracket plate, and drill a hole on wall and make sure it is
big enough for the BNC connector and power jack to pass through.

DVR
Video
Power
Adaptor
extension cable
(not included)
2). If cable is does not need to go through walls, the cable can be fixed
directly to the wall surface.
3). Connect the BNC end of the camera to the extension cable and the
other end of the extension cable connect to your DVR.
Installer connects either 12VDC or 24VAC to the screw terminals.
(polarity is not important with either voltage).

200
o
360
ZOOM
FOCUS
o
360
o
4). Power up the camera and video should appear on screen.
5). You may now adjust the camera viewing angles by adjusting the
camera bracket position.
6).
Loosen the screws of the camera bracket, adjust the Pan，Tilt and
rotate mechanism by hand, once the desired viewing position is
achieved, tighten up the
camera bracket screws to fix the position
"as shown in below photos".
7). The camera is equipped with a Vari-Focal Lens for zoom in / out
feature. To Zoom, you must rotate the handle on the camera body
and adjust the focusing to get the best image.

SETUP MENU
LENS AUTO
SHUTTER/AGC AUTO
WHITE BAL ATW
BACKLIGHT OFF
PICT ADJUST
D-WDR OFF
MOTION DET ON
NEXT
EXIT SAVE ALL
←
←
←
←
←
←
SETUP MENU
PRIVACY OFF
DAY/NIGHT EXT1
2DNR
CAMERA ID OFF
SYNC INT
LANGUAGE ENGLISH
CAMERA RESET
BACK
EXIT SAVE ALL
←
←
←
←
←
ZOOM UP
SET
LEFT RIGHT
DOWN FOCUS
OSD button cover
8). The camera is equipped with a OSD menu, you must remove the
OSD button cover of the camera body, press the up, down, left and
right buttons and adjust the image effects to get the best image.
9). The camera is now all set up, close the camera OSD button cover.

NTSC:976(H) × 494(V)
OSD Key control
OSD
BSS7212 / BSS7550
97(W)x 81 (H) x 168(L)mm (Body only)
2:1 Interlace
700
58
0.1Lux Color; 0.01Lux B/W (IR LED's On)
Automatic Tracking
2.8-12mm or 5-50mm Varifocal
or AC 24V
1/3” Color SONY Super HAD CCD II Image Sensor
650
140
IR
LED OFF
IR
LED ON
Scanning System
ss
, BNC
80
NR-MODE / Y Level / C Level
OSD Key control
2DNR
OFF / HLC / BLC
ON / OFF
ON / OFF
ON / OFF
Backlight
D-WDR
Motion Detection
Privacy
EXT1 / B&W / Color / Auto / EXT2
Day / Night
Pict Adjust
7
More than 30m(100ft)
IR Range
IR LEDS
42