AUDAC RGA10 User manual

RGA10
Installation Manual
www.audac.eu

2
Introduction
Omnidirectional outdoor FM antenna
The RGA10 is an omnidirectional outdoor FM antenna designed to be used in all kinds
of installations, providing the best reception of FM radio signals where any kind of radio
tuner is used.
The aluminum structure of the antenna ensures resistance against all weather conditions
and ensures it will last for many years in highly demanding outside environments.
The attachment clip ensures a quick and simple installation of the antenna around any
kind of poles with a diameter between 30 and 50 mm. While the connection is made by
means of an included waterproof F-connector.
Features:
- Omnidirectional
- Made out of aluminum
- Easy to install
- Best reception
- 30-50 mm mounting clip
- F-connector with waterproof boot included

3
Instructions
Assembling and connecting
The RGA10 consists of three parts, two radials and a middle section, which should
be assembled together. The two radials are bended in a circular shape. To attach the
radials to the middle section, the two bolts on the top side and the two nuts on the
bottom side of the middle section need to be removed.
The next step is to place the two radials in their correct position by placing them into
the sockets, place the bolts and washers back into their position, and tighten the
screws to fix them.
It can be attached to a pole with a diameter of 30-50mm, by means of the mounting
clip in the center position of the RGA10.
To connect a coaxial cable to the RGA10, the coaxial cable should be stripped as
shown in the figure below. Then slide the waterproof boot over the cable outer jacket,
and assemble the F-connector to the cable end. Afterwards, the connector should be
attached to the connection terminal on the bottom side of the antenna.

4
Additional information
Technical specifications
Frequency range 87.5 ~ 108 MHz
Impedance 75 Ohm
Antenna gain 4 dB
Horizontal / Vertical beamwidth 360°
Dimensions 􀃘􀃘􀃘􀃘􀃘 450 x 80 mm
Weight 590 g
Mounting 30 - 50 mm pole
Contruction Aluminum
Connector F-connector (included)
Antenna sensitivity diagram