AudioBahn ABP101N User manual

SINGLE SUB ORTED SYSTEM
ABB101N / ABB121N
OPERATING INTSTRUCTIONS
PLEASE RETAIN MANUAL FOR FUTRE USE AND REFERENCE
QUALITY, RLIABILITY, & PURE BLISS

Features and Specifications

ABB121N
Single 12"
Ported Bass System
ABB101N
Dual 10"
Ported Bass System
High Quality MDF Construction
Black Carpeted Covering
Extended Low Frequency Slotted Ports
Audiobahn Embroidery
12” IMPP Cone with EPDM
Rubber Surround
45 oz. Strontium Magnet
2" 4 Layer Voice Coil
Bumped Back Plate
Extended & Vented Pole Piece
Gold Binding Post Terminals
Power Handling: 400 Watts RMS
Sensitivity: 94.5dB
Frequency Response: 25Hz-1kHz
Impedance: 4 Ohm Mono
Dimensions:
High Quality MDF Construction
Black Carpeted Covering
Extended Low Frequency Slotted Ports
Audiobahn Embroidery
10” IMPP Cone with EPDM
Rubber Surround
45 oz. Strontium Magnet
2" 4 Layer Voice Coil
Bumped Back Plate
Extended & Vented Pole Piece
Gold Binding Post Terminals
Power Handling: 300 Watts RMS
Sensitivity: 93dB
Frequency Response: 29Hz-1kHz
Impedance: 4 Ohm Mono
Dimensions:
14 7/8"(H) x 18 7/8"(W) x 9 7/8"(D)

Wiring And Hookup
5
The box is wired in a mono 4 ohm operational mode. Looking at the back of the box you will see the
terminals. The left terminal is negative (-) and the right terminal is positive (+) for each set.
The mounting position of your ported enclosure will have a great effect on the sound performance produced.
TRUNK MOUNTING
Placing the box in the trunk provides a good overall performance.
PASSENGER COMPARTMENT MOUNTING
Placing the box in the passenger compartment provides optimum sound, but reduces the area for passenger
seating, if not taking it all away.
LOADING
Facing the box towards a wall will increase the low frequency sounds. When mounting in a trunk or back of
any vehicle, you will tend to get much better performance and better low end frequency response when you
face the box towards the back of the vehicle.
MOUNTING
Mounting or securing the box is a good idea. This will prevent the box from sliding around. If it does move
around, it can hit obstacles, and wires can come loose and damage the system. It is also good to have it
secured in case of an accident so it is not thrown into any passengers.
You can mount the box by attaching brackets and fastening it with screws or bolts straight to the frame or
other solid piece in the car. You can also use velcro strips. Attach the sticky side of the velcro to bottom of
the box, and the carpet in the vehicle should hold it in place.