Audiolab DC BLOCK User manual

User Manual
DC BLOCK
C
M
Y
CM
MY
CY
CMY
K
DC BLOCK manual_A5.pdf 1 2020/12/10 10:26:03

1: Important Safety Information Page 2
C
M
Y
CM
MY
CY
CMY
K
DC BLOCK manual_A5.pdf 2 2020/12/10 10:26:03

Quick Instruction Guide
Unpacking:
Unpack the product fully, the carton should contain:
• The audiolab DC BLOCK
One IEC mains power cord suitable for your area
One IEC C14 to C13 jumper cord
•
•
2: audiolab DC Block - Mains Conditioner (DC+RF filter) Page 3
Functions：
1. High frequency filter suppressing noise on the mains power line.
2. Blocks DC on the mains power line.
If an item is missing or damaged report this to your dealer as soon as possible.
Retain the packing for safe transport of your unit. If you dispose of the packing,
do so with regard to any recycling regulation in your area.
Specifications:
Power Requirement: 100-240V ~ 50-60Hz
Peak Load (1) : 600VA
Audio Power Amplifier Compatibility (2) : < 2x150W or < 1x300W
Dimensions (W x H x D): 113 x 59 x 140 (mm)
Weight (net): 0.7kg
Connection:
Make sure the ON/OFF switch on the unit you are going to use is switched off
before the operations below.
Note
The DC BLOCK is designed for audio equipment with variable power require-
ments up to maximum peak load, and should not feed any permanent high
power loads such as heaters or similar.
Connect the supplied jumper cord from the output of DC BLOCK to the unit
you are going to use (ie. audiolab power amplifier)
Connect the supplied mains power cord from the input of DC BLOCK to the
AC supply outlet
1.
2.
(1)
(2)
C
M
Y
CM
MY
CY
CMY
K
DC BLOCK manual_A5.pdf 3 2020/12/10 10:26:03

3: Warranty Page 4
Audiolab IAG House, 13/14 Glebe Road, Huntingdon,
Cambridgeshire, PE29 7DL, UK
Tel: [phone]
Email: [email protected]
http://www.audiolab.co.uk
Email:
C
M
Y
CM
MY
CY
CMY
K
DC BLOCK manual_A5.pdf 4 2020/12/10 10:26:03