
Replacement Instructions
1. Remove the entire lter system from your shower pipe by turning
the chrome swivel collar counter-clockwise. (FIGURE A)
2. Remove the shower head from the lter system.
3. Remove the lower lter cartridge by turning it counter-clockwise.
(FIGURE B)
4. Unwrap the new replacement cartridge and remove the yellow label
and yellow plastic shipping cap from the top end of the cartridge.
5. Install the new cartridge by turning it clockwise.
• Tighten rmly by hand — if the lter is not tightened rmly it will leak around the seam
between the upper lter housing and the cartridge.
6. Re-attach the lter sustem to your shower pipe by turning the
chrome swivel collar clockwise.
• Make sure that the white washer is still in place inside the chrome swivel collar.
7. Before re-attaching the shower head, turn on the water to ush and
activate the lter until water runs clear.
• Use cold water for the initial ushing.
• Wait 30 seconds for temperature change.
• Run water until clear and then turn off and back on several times.
• Repeat this procedure until the initial surge of water is clear.
FIGURE A
FIGURE B
Note: do not remove the
lter cartridge while the
lter is still attached
to the shower pipe, this
may cause damage
to the lter where it
connects to the shower
pipe, or to the pipe
connection behind the
shower wall.
The initial surge of water will be
discolored with carbon nes and may
soil your shower stall. This carbonized
water is benecial to plants and the
environment. It can be discarded in a
plant bed or down the drain.