Aura RVC-62AHD User manual

RVC-62AHD
Universal Rear View Camera

Installation Procedure
ATTENTION
To prevent injury or fire, take the following precautions:
• Installation and wiring of this product require specialist skill and
experience.
PRE CAUTION
To prevent damage to the product, take thefollowing precautions:
• Make sure to ground the unit to a negative 12V DC power supply.
NOTE
• A Rear-view camera is a camera that provides symmetrical images in the
same way as rear and side view mirrors.
• Connection to a TV with an RCA video input is possible, but confirm
whether the TV you use has a reverse gear connection function.
• This Camera features a wide-angle lens, so the near view is wide and
the far view is narrow, which may create a false sense of distance
• Check camera bracket installation before driving. Are the
screws loose?
- Is the camera bracket firmly secured?
- If the rear- vie w camera comes loose while you are driving it may cause
an accident.
•
Before finally installing the unit, connect the wiring temporarily, making
sure it is all connected up properly, and the unit and the system work.
• When mounting this unit, make sure none of the leads are trapped
between this unit and the surrounding metalwork or fittings.
Installation Procedure
1 To prevent a short circuit, remove the key from the ignition and
disconnect the battery.
2 Make the proper input and output wire connections
for each unit.
3 Connect the wiring harness wires in the following order: ground,
ignition and camera unit.
4 Install the unit in your car.
5 Reconnect the battery.
Accessories
1. Power Cable 1.5m –1Pc
2. Video Cable 6.0m –1Pc
3. Hole Saw Driller –1 Pc
4. Instruction Manual
5. Warranty Card

Installation
Recommended Installation Position
1. Drilling Installation –Above license plate light
Using Hole Saw Driller Pierce a hole.
Mount the camera onto the hole.

Basic Connections –Type 1
Basic Connections –Type 2
Depending upon Head unit compatibility, chose the connection as below
1. AHD -PAL CONNECTION METHOD
Connect white line (cut off the white PVC sleeve, connect copper wire on both sides )
2. CVBS-NTSC CONNECTION METHOD
Default state: white line has been cut for ex-works test.
Note: We recommend changing the video camera operation modes when the
device is turned off. The video camera must be reset after wire has been
connected.
Headunit
fill
Camera

Specifications
Item
Description
Image Sensor
CMOS 1/3
Output formats
PAL/NTSC
Effective Pixel Array
1280(H) x 720(V) AHD –733(H) x 493 (V) CVBS
Resolution
1.0MP
Day and Night Mode
Colour
Video Amplitude
AHD/CVBS
Day/Night Mode
Auto
Video Signal
AHD/CVBS
Exposure
Auto
Gain Control
Auto
White Balance
ATW
Min. Illumination
0.02Lux@ (F1.2, AGC ON)
Wide Angle Diagonal
170°
View Angle
Horizontal 140°
Vertical 100°
Image Character
One switchable line: AHD PAL or CVBS NTSC switchable
Working Voltage
12V DC
Working Current
80±10mA
Working Voltage Range
9~15V DC
Working Temperature
-25~+70℃
Storage Temperature
-30~+75℃
Image Quality Assurance
Temperature
-25~+70 ℃
Environment Humidity
90%RH
Waterproof Grade
IP68