DV8 FBJL-02 User manual

FBJL-02
2018+ JL/JT Premium Modular Front Bumper

2
1. Begin by unpacking all items and inspecting them for damage or missing items. Any
concerns, please contact the company you purchased the bumper from.
2. After inspection, remove your factory bumper. With the front of the frame rails clear, install
the winch plate using the provided M12 hardware. NOTE: Ensure the winch plate is centered
on the frame rails.
3. Once winch plate is secure, install the main center section of the bumper by sliding it over
the top of the winch plate. The bumper should wrap over the D-Ring mounts like shown in
image below.

3
4. Align the 8 holes on the top of the bumper with the winch plate below. Secure the 4 holes
closest to the center with our taper allen head bolts and rock washers provided in the
hardware kit.
5. After the center section of the bumper is secure, install the winch.
21-3/4”
7-1/4”

4
6. If you are going to install our BS10E50W5W, install the light now with the hardware supplied
with the light.
7. Install the wings (included stubby) or (full-width FBJL-02W) with the provided rock washers
and hardware. The hole in the front of the stubby wing will remain open at this point.
8. Install your fog lights into the skid plate.
Top
Bottom

5
9. Install the Skid plate onto the Jeep using the provided long bolts. These bolts will go
through the frame horn on each side of the Jeep. Keep bolts loose.

6
10. Once the two lower skid plate bolts are loosely installed, rotate skid plate up, and use the
provided bolts to secure the top portion of the skid plate to the main bumper and wing.
Once installed, you can secure the lower frame horn bolts.
11. lastly, Install your fairlead and connect your fog lights and ensure all your hardware is
secured. and you are done!
If you have any questions, please email us at [email protected]
or call us at 951-680-9595