Auralex Acoustics Elite Pro System EPS-112T Instruction sheet

Installation Guidelines
Thank you for Purchasing Auralex®Total Sound Control® Products!
Elite Pro System EPS-112T Components
Congratulations on purchasing an EPS-112T™System from Auralex®Acoustics. You’re
now on your way to creating a world class listening environment.
Elite Pro Systems offer a sophisticated look by utilizing products covered with specialized
acoustical fabrics. The EPS-112T system contains both B22 ProPanels™and CT45 Bass
Traps™, which when used together, provide incredibly effective broadband absorption in
any room. Use the EPS-112T alone for treatment of small to medium-sized rooms or in
combination with other Auralex products for full control of larger spaces.
B22 ProPanels™
20
CT45 Bass Traps™
4
Impaling Clips
80
™
Elite Pro Systems
EPS-112T
Tubetak Pro™
1
846-606 | Rev. 1 | 070506 EF

Recommended Additional Installation Materials
• Power Drill • Tape measure
• Carpenters Level • Small ladder (depending on ceiling height)
• Pencil • 16 2.5” 4D finish nails
• Straight Edge • 160 .75”-1” drywall screws
• Nail Set • Hammer
Elite Pro System EPS-112T General Information
B22 ProPanel Installation Guide
➋Install four impaling clips within marked B22
ProPanel location using drywall screws. Exact
placement of each clip is not necessary.
➊Mark intended location of each B22
ProPanel on the wall or ceiling.
Marked panel
outline
➌Start the B22 ProPanel 5/8” above its intended
final height and press downward at a 45° angle
until the panel is flush with the wall or ceiling
surface.
TIP
For permanent mounting, apply Tubetak Pro
adhesive to the back of the B22 ProPanel
before completing Step 3.
CAUTION
Always use Tubetak Pro on the back of the
panel when attaching it to the ceiling.

CT45 Bass Trap Installation Guide
16.75”
➊Mark a vertical line 16.75” from the intended
placement corner on both sides. ➋Hold CT45 Bass Trap in corner with edges
aligned to the marked vertical lines.
➌While continuing to hold panel in place, install
one finish nail though the fabric face and the
hardened edge of the CT45. Do not hammer
nail completely flush with the face of the panel.
Make sure finish nail is installed perpendicular
to the wall surface. Repeat in each of the four
corners.
➍Using a nail set or another finish nail, carefully
countersink installed nail so its head goes
through the fabric surface of the CT45 but not
through the hardened edge.
➎Once the finish nail has been countersunk into
the panel, there may be a small hole remaining
in the fabric covering. Simply scrape the fabric
in this area with your fingernail and the hole will
completely disappear.

Elite Pro System Installations
See the Auralex®Acoustics website, www.auralex.com, for more information
about these and other Total Sound Control®products.
These are general recommendations. Should you have any additional questions about the installation of your
Elite Pro System, feel free to contact an Auralex®Application Specialist
via email at [e-mail] or call 1-800-95-WEDGE.