AURES Posligne OLC15 User manual

Quick setup guide for the
Posligne OLC15 touchscreen monitor
The following items should be packaged with the Posligne OLC15 touchscreen monitor -
- Power cable
- VGA cable
- USB cable (for touch operation & customer display
- RS232 cable (for operation of serial card reader or i-button reader)
- Drivers CD
If your OLC15 touchscreen monitor has been shipped with a keyboard wedge card reader
or if you wish to use the i-button reader via keyboard wedge, then a PS/2 to PS/2 cable
should also be included.
If this cable has not been included; please request one from your sales contact.

1. Connect the power cable 2 Connect the VGA cable between
the monitor & the PC
3. Switch the touchscreen on using the button at the rear of the screen
4. Install the Touch Utility software from the drivers CD - Common\POS-TOUCH &
connect the USB cable

5. Install the driver for the USB to COM device from the drivers CD - Common\USB2COM
This driver will install a virtual com port to allow access to the customer display
To find the com port number, you should check the Ports section in Windows Device
Manager (see below)
The default communication settings for the display are 9600, n, 8, 1
Further information regarding the operation of the Posligne OLC15 touchscreen
monitor is available in the manual that is included on the drivers CD -
Common\Datasheet\OLC15_OLC_15_User_Manual_V_1_0.pdf