AuthenTeak Kingsley-Bate Chippendale CH50 User manual

Kingsley-Bate
CH50 Chippendale 5' Bench
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE CH-40/50
RIGHT END FRAME BACK LEFT END FRAME
1* NOTE :
9A TENON
B MORTISE HOLE
SEAT
2STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE : During assem bly of furniture please matc h joints with the co rresponding letters or
numbers stamped near the joints.
3STEP-II
Carefully lay the END FRAME with the stamps on a clean, flat surface and fit
the BACK tenons into the END FRAM E mortise hol es as shown. If
necessary, gently rock th e BACK while pushing the tenons into the mortise
holes until joints fit snugly together.
4STEP-III
Place SEAT against END F RAME as s hown on assem bly photo and insert
back center SEAT support tenon into bottom rail of BACK mortise hole.
5STEP-IV
Place FRONT SEAT RAIL tenon into end frame mortise hole (m ake sure
rounded edge of FRONT S EAT RAIL is facing up). Place center SEAT
support tenon into FRONT SEAT RAIL mortise hole.

6STEP-V
Fit the remaining END FRAME m ortise holes over and onto all exposed
tenons as shown in phot o. Using a rubb er hammer or regula r hammer with a
wood block between the hammer and the wood, drive the t enons and mortise
holes together until all joints fit snug ly. NOTE: Upright bench by LIFTING
and SETTING down, tilting bench over wh ile dowels are not secured could
cause damage to the bench.
7STEP-VI
Hammer dowels into respective joints m aking
sure not t o hit other parts of the bench. To
avoid dimpling the wood, we suggest you
place a b lock of w ood between the dowel
head and the hammer head on the last few blows. If dowels are not com pletely flush, use a
saw to cut the ends and then sandpaper to smooth the tops. DO NOT FORCE DOWELS
FURTHER THAN THEY WILL GO.
8STEP-VII
Insert brass screws into respective pre-drilled holes under the SEAT as shown
in the photo. Do not hammer in the sc rews, but drive them in with a prope r
screw driver; use of a power screw driver could easily strip the holes.
STEP-VIII
Attach the decorative brackets to the END FRAMES and to
the FRONT STRETCHER. Make su re the longest end of the
bracket fits under the FRONT STRETCHER. Brackets are for
decorative use only.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]