AUTLED LC-004-700 User manual

LED DALI Signal Repeater - User Manual
Item no.: LC-004-700
1. Product Description
The DALI Signal Repeater is a device to enhance the maximum DALI cable length from 300m up
to 600m. Either radially arranged network layout or cascaded swystem mounting operated with
single master. The maximum amount of DALI-devices in the total network is limited to 64, the
devices can be divided on the subcircuits at will. Suitable for Din-Rail mounting.
3. Description
2. Specification
1. Device to enhance the maximum DALI cable length from 300m up to 600m
2. Enhancement and Transmission of the DALI-signals (bidirectional).
3. Galvanic separation between DALI-circuits
4. Either radially arranged network layout or cascaded system mounting operated with single
master.
5. restricted cascading (Series wiring) of multiple repeaters in multi-master operating mode
6. The maximum amount of DALI-devices in the total network is limited to 64, the devices can be
divided on the subcircuits at will.
7. For each subordinate DALI circuits a separate power supply is needed. (DALI PS).
8. Suitable for Din-Rail mounting.
power supply via DALI- Bus
typ. current consumption
(main control/sub control circuit)
6 mA / 4mA
DALI IN / Input DALI
DALI OUT / Output DALI
mounting DN-Rail
max. wire corss-section 2,5 mm2
dimensions (L x W x H) in mm 120 x 41 x 22 mm
weight 78g

4. Dimensions
Max. 64 DALI Aktoren
Max. 64 DALI Actuators
DA
DA
DALI
AKTOR
G4
DA
DA
DALI
AKTOR
G3
DA
DA
DALI
AKTOR
G2
DA
DA
DALI
AKTOR
G1
DA
DA
DALI
AKTOR
G8
DA
DA
DALI
AKTOR
G7
DA
DA
DALI
AKTOR
G6
DA
DA
DALI
AKTOR
G5
N
L
230V~
POWER
PE
DALI PS Bus Stromversorgung
DIN Rail Montage | Bus Power
Supply DIN Rail Mounting
LC-004-200
DA
POWER
IN
230V~
DAN
L
DALI
OUT
max.
250mA
ca.16V=
DALI Signal Repeater
LC-004-700
DALI
IN
DA
DA
DALI
OUT
DA
DA
N
L
230V~
POWER
PE
DALI PS Bus Stromversorgung
DIN Rail Montage | Bus Power
Supply DIN Rail Mounting
LC-004-200
DA
POWER
IN
230V~
DAN
L
DALI
OUT
max.
250mA
ca.16V=
5. Wiring Diagram
Connection
The sequencer-module has to be connected directly to the DALI bus. It is supplied with power
by the DALI bus and does not need any additional power supply. A typical value of the current
consumption is approximately 2mA. In order to supply additional components on a DALI line the
installation of a power supply (DALI PS) is required. The connection to the DALI-line is polarity
free and immune to overvoltage. The module fits into a standard lush mount box.