Autodoner G500 Owner's manual

1
THIS GAS-FIRED APPLIANCE IS FOR COMMERCIAL USE AND NOT FOR HOUSEHOLD USE.
PURCHASER OF THIS GAS APPLIANCE SHOULD POST INSTRUCTIONS IN A PROMINENT LOCATION.
TO BE FOLLOWED IN THE EVENT THE USER SMELLS GAS.
THIS INFORMATION IS AVAILABLE FROM YOUR LOCAL GAS SUPPLIER.
FOR YOUR SAFETY
Keep gasoline and other flammable vapors and liquids away from this or any other appliance.
Keep this gas-fired appliance and the surrounding area free of combusbles.
Keep the vent holes on the top and back of this unit free of obstrucons to provide proper airflow for
combuson and venlaon.

2
INCLUDEDINBOX
#11601 SkewerComplete withMeatBase#12000 CatchPan
#11700 DripPan#11710 DripPanCover

3
INSTALLATION
Thisapplianceisforcounter‐topplacementunderaventilatinghoodforfumeremoval.Installationshallnotbe
closerthan6”fromsidewalland3”fromrearwall.
InstallationmustbebyalicensedplumberorgasfitterandbeinaccordancewiththeNationalFuelGasCode,ANSI
Z223.1,NFPA#54‐2002Sec.10.3.5.2,andNationalElectricalCodes,ANSI,NFPA#70‐1981.
Beforeconnectiontogassupply,checktagonrearofunit.Thisappliancemaybeset‐upforusewithLPGas,in
whichcase,youshoulduseanexternalregulatordesignedforusewithLPgas,setan11”W.C.Inaddition,hoses
andcouplingstofit½”FPTthataresuitableforLPgasshouldbeused.TheseareavailablefromyourlocalLPGas
distributor.
Onunits’labeled(NAT)naturalgas,useaflexiblegasconnector(1/2”MPT)toconnectgaslineinfacilitytothe½”
FPTatthebackoftheAutodoner.Thegaslineshouldbeequippedwithashutoffvalve.Noexternalregulatoris
needed;theseunitsareequippedwithafactorysetregulatorforNaturalGas.
Theapplianceisequippedwithathree‐prong(grounding)plugforyourprotectionagainstshockhazard.Itshould
bepluggeddirectlyintoaproperlygroundedthree‐prongreceptacle.Donotcutorremovethegroundingprong
fromthisplug.Thisappliancewheninstalledmustbeelectricallygroundedinaccordancewithlocalcodes.
TOLIGHTPILOTS&BURNERS
Turnthegasvalveknobsonfrontofunitclockwiseto“OFF”position.Opengasflowtogaslineandwait1minute.
Lightthepilotsatlowerpartofburners.Thepilotshouldstayonallthetime.Turnthegasvalveknobcounter‐
clockwiseto“ON”positiontolightthemainburners.
TOSHUTDOWN
Tolowerorshut‐offmainburners,turngasvalveknobclockwise(OFF).
Toshut‐offpilots,closegasvalveongasline.
Donotattempttore‐lightburnerswithoutwaiting5minutes.
COOKINGANDHANDLINGINSTRUCTIONS
(FORGYROS,DONERKEBAB,&SHAWARMA)
Asyouwellknow,whendealingwithrawmeat,strictadherencetoacceptedcookingdirectionsismandatory.The
followingdirectionscoveringthecookingandservingofMeatCones,whichcomesfromPublicHealthsourcesall
overthecountry,willprovideyouwithalltheinformationyouneedtoserveyourcustomersaconsistentdelicious
andsafesandwiches.

4
LOADING MEAT CONES:
1. Place skewer through hole in cone, with smaller diameter of cone supported on the round disk of the skewer.
The higher the meat is placed on the skewer, the faster it cooks. ALWAYS LOAD FROZEN, NEVER THAW.
2. Pull out the upper and lower skewer supports. Place skewer through the upper support first and then lower the
skewer through the drip pan to engage the motor drive.
3. Adjust upper and lower supports so that the meat is 4”–5” away from the heang element.
4. Meat turns very slowly. If the cone is not turning, the lower part of the skewer may not be seated in the motor
hole properly.
COOKING MEAT CONES:
1. Turn the motor and burners on and let cook unl browned outside. ATTENTION: MAKE SURE THE MEAT YOU
SERVE IS FULLY COOKED! (Minimum Internal Temperature of 158° or higher for Beef & 170° for poultry or
pork). We suggest that you further cook any poultry or pork product on a hot grill to ensure a 170°
temperature.
2. A “probe type” food thermometer must be kept readily available and rounely used to monitor food
temperatures during preparaon and storage.
3. Slice the meat thin as possible with a 14” straight edge beef slicer or electric slicing knife.
4. The meat cone must cook connuously unl completely carved. The cooking may be stopped to allow for safety
during the carving acon only; (UNDER NO CIRCUMSTANCES CAN THE BROILING UNIT BE TURNED OFF AND
ON DURING THE DAY TO COMPENSATE FOR SLOW SALES PERIODS).
5. If undercooked meat is cut it MUST BE PLACED ON A GRILL/GRIDLE AND ALLOWED TO FULLY COOK.
6. The size of the cone should be determined by business volume demand. The expected me for the total cooking
of the Gyros cone is 3-4 hours.
7. All sliced meat must be held at 165° F. or above in a steam cabinet unl served.
8. Knives and catch pans must be cleaned and sanized before use and aer cuts are made that are deep enough
to penetrate or slice into undercooked meats.
9. At the end of the day, all remaining meat MUST be cooked and carved. No cooked meat can be taken off the
skewer and refrigerated. The cooked slices must be held under refrigeraon at 45° F. or below in shallow
covered pans.
10. All leovers must be heated rapidly the following workday to minimum of 165° F. unl served. (Grill,
Microwave, etc.)
For consistent, quality product, please insure that your operaon strictly adheres to the preparaon direcons
listed above.
MAINTENANCE
This appliance should be cleaned regularly.
Removable parts (skewer, catch pan, drip pan, meat base, and heat shields) can be run through the dishwasher
with your other pots and pans.
Oven cleaners (e.g., Easy-Off) may be used to clean stainless steel surfaces. Care should be exercised not to get
oven cleaner on burner screens or ceramics. They may be protected by covering them with aluminum foil.
The motor bearing is permanently lubricated, and it does not require maintenance.
No other maintenance is required.
120 Stanley St., Elk Grove Village, IL 60007
Toll Free Phone: [phone]
Fax: [phone]
www.autodoner.com

PARTS AND ACCESSORIES
#16530 - Gas Knob
#09818 - Heat Shield - Set (Polished)
#12800 Motor 120v with Fan #12820 Flange Bearing#12840 Motor Switch
#09810 - G500 Burner Natural
#09812 - G500 Burner L.P.
#09807 Burner Screen
#12850 Indicator Light 120v #11630 Skewer Holder Clip #12950 Handle Nut
#11640 Skewer Stand #12010 Gyros Knife 14" Blade
#20000 Super Gyros Knife - Stainless Handle (80mm Blade)
#20001 Super Gyros Knife - Plastic Handle (65mm Blade)