Cornelius IDC PRO 255 User manual

1
Cornelius IDC PRO 255
Splash Panel Installation and Removal

2
Removing the Upper Splash Panel
•Remove the thumb screw
behind the door
•Pull the panel up and
forward to release. Guide
the panel down making sure
to clear ice dispense lever
and nozzles
•NOTE: Re-insert thumb
screw to avoid losing it.

3
Lower Splash Panel Removal
•Loosen 2 screws; one on each side of lower splash
panel. You may have to completely remove the
screw on the right side due to the ADA panel.
•Slide splash panel up & pull forward and out from
the bottom
•Note the tabs at the bottom of the splash panel
•Take care to not damage the ADA keypad while
removing the panel
•Keyholes
Lower Tabs

4
Lower Splash Panel Installation (standard and Z-Style)
•Slide the splash panel keyholes over the screws.
•Apply slight pressure on the frond side of the splash
panel (one side at a time) and push down to seat
the lower tabs. Starting on the left side simplifies
the installation. Once fully seated, tighten the
screws to secure the splash panel.
Lower Tabs

5
Installing the Upper Splash Panel 5
•Guide the upper splash panel up around the ice dispense lever and the dispensing nozzles.
•Align the two hooks on each side of the upper splash panel with the two slots on the right side
and left side of the cladding. Insert the hooks into the cladding and push down to ensure the
hooks lock into place.
•Insert the thumbscrew and tighten down.
•Close the merchandiser and check for ice agitation and dispense.
**Improperly installed upper nozzle cover can interfere with the touch screen closing completely.
This will prevent ice agitation and ice dispense
•Slots in cladding
•Hooks on nozzle
cover