Avido KL10000 Operating and maintenance manual

Avido™10,000mAh Power Bank-
Instructional Manual
Thank you and congratulations on your
purchase of the Avido™ 10,000mAh Backup
Battery. To get the most of your new product,
please read these instructions before use. Enjoy!
Charging the Power Bank
1. Using the Micro-USB Cable, connect the
Micro-USB connector into the “IN”input on the
Power Bank, and the Standard USB connector to a
USB Power Source, such as a laptop computer or
smartphone USB charger.
2. The LED screen will indicate the current charge
level and show progress as the charge progresses.
3. When fully charged, the power bank LED will
read“ 100%”charge.
Normal charging time of the Avido™ 10,000mAh
Power Bank is approximately 6 hours.
You can check the charge on the Power Bank at
anytime by pressing the ON/OFF button on the
side of the unit. The LED display will indicate
voltage, remaining charge life in %, and charging
amps.
KL10000
KL10000
1.0A
2.1A
The following illustration is shown with an iPhone 6
Phone Cable
AC Outlet / Adapter
Micro USB Cable (Included)
Charging the Power Bank
Charging Your Mobile Devices
Electronic
Device
Device Cable

Safety
Improper use of this product may result in product
damage, excess heat, toxic fumes, re or explosions,
for which damages you (“Purchaser”), or
(“Manufacturer”) are responsible.
• Use only a 5V power adapter for charging,
otherwise you may cause damage to the
device.
Charging the Power Bank (continued)
It is recommended that you charge your Avido
KL1000 Power Bank fully after purchasing the unit
and prior to use.
Charging Your Digital Devices
Using the charging cable that was provided with
your portable electronic device (i.e., Phone, iPad,
Tablet, Portable Speakers, etc.) plug the USB end
of the cable into an OUTPUT port on the side of the
Avido KL10000 Power Bank. Plug the other end of
the charging cable into your electronic device.
Charging will begin and the LED display will notify
you of the charge progress.
• OUTPUT 1 is a 1A charging port and suitable
for charging phones and smaller portable
devices.
• OUTPUT 2 is a 2.1A charging port and should
be used for charging iPad’s and Tablet Devices.
You can use this output port for charging your
phone or other devices as well.
Depending on your device, the Power Bank may
automatically shut-o to conserve power.
LED Screen
Press the ON/OFF button which turns on the Avido
KL10000 Power Bank and provides the current
charge condition.
Press the ON/OFF buttons twice to show the Avido
KL10000 Power Bank charge conditions (voltage,
remaining charge life in %, and charging amps.)
If no devices are connected to the Avido KL10000,
it will turn o automatically after about 5 seconds.
When the KL10000 is o, the LED will not be
illuminated.
Specications
1. Battery Type: Lithium-Polymer
2. Battery Capacity: 10000mAh
3. Input Power 5.0V, 0.5V/2A
4. USB Output: Output 1 = 5VDC 2.1A &
Output 2 = 5VDC 1A
5. Dimensions: 3”W x 5.25” L x 0.5” H
6. Weight: 5oz
Accessories Included
• Micro USB Charging Cable
• Micro Fiber Carrying Pouch
• The product is not suitable for children as it
contains fragile parts that may be swallowed.
• Do not drop or immerse in water as the unit
will be damaged.
• Do not expose to high tempartures or
ammable gases.
• Do not remove the housing.
• If there is any damage to the battery such as dents,
punctures, tears, deformities or corrosion, due to
any cause, discontinue use and contact
manufacturer or dispose of it in an appropriate
manner at your local battery recycling center.
Warranty
Avido warrants this product to be free from defects
in materials and workmanship for 1-Year. If your
Avido accessory is found to be defective within that
time frame, we will promptly repair or replace it. This
warranty does not cover accidental damage, wear
and tear, or consequential or incidental loss. If you
are in need of warranty support, please email
[e-mail].
Customer Support
Please visit our website www.avidopower.com for
additional information and support.
Avido, LLC
Design by Kevin Lance
1-844-MY-AVIDO