AVL K Series User manual
Add casters to a K-series Loom
Updated: June 8, 2021 Page | 1
AVL Looms
2360 Park Avenue
Chico, CA 95928-6785
U.S.A.
Drill%the%holes%for%the%casters%
There are four casters, which should be placed at each corner of the loom.
The holes that need to be drilled are size H or 0.266 inch diameter. Two thru
holes will need to be drilled for each bracket.
Note:
The casters are attached to the side of the loom. On the rear legs, the holes
are drilled through the narrow side of the leg. Please read all of this handout
and review the pictures on pages 3 & 4 before drilling the holes.
1) Use the front casters diagram to determine where the holes should
be drilled on the front legs. Mark the position of the hole on the
loom.
Figure 1 - Drill diagram for front legs
Add casters to a K-series Loom
Updated: June 8, 2021 Page | 2
2) Use the rear casters diagram to determine where the holes should
be drilled on the rear legs. Mark the position of the hole on the
loom.
Figure 2 - Drill diagram for rear legs
3) Drill thru the frame at the marked holes using a size H (.266”)
diameter bit.
Attach%Casters%%
One of the available options for the K-series loom is wheeled casters which
allow the loom to be easily moved from one location to another. When the
loom is not being moved, the casters are securely locked into position.
Note:
The casters at the front of the loom are positioned at the sides. The casters at
the rear of the loom face the back.
1) Find the four casters and the hardware. There are four long bolts
and four short ones. The short bolts are used on the front of the
loom and the long bolts are used at the rear.
2) Place a caster on the front leg of the loom against the drilled holes
on the side frames, with the bracket facing up. Place the short bolts
through the holes in the caster and the loom from the inside of the
loom.
3) Secure each bolt with a nut.
4) Repeat for the other front leg.
Add casters to a K-series Loom
Updated: June 8, 2021 Page | 3
Figure 3 - Caster attached to front leg of the loom
5) Place a caster at a rear leg of the loom against the drilled holes,
with the bracket facing down. Use the long bolts to secure the
casters to the loom.
6) Secure each bolt with a nut.
7) Repeat for the other rear leg
Add casters to a K-series Loom
Updated: June 8, 2021 Page | 4
Figure 4 - Caster attached to rear leg of loom
Table of contents
