Axio MET AX-9319 User manual

LCD DIGITAL POCKET SIZE
THERMOMETER
AX-9319
INSTRUCTION MANUAL

2
FUNCTIONS:
•ON/OFF
•H/T
•°F/°C
•MAX/MIN Memory recalling
FEATURE:
•250 mm Stainless steel sensor pro e
•1 second normal temperature sensing time
•Piercing pro e
•Protective plastik sleev with clip for stainless steel
SPECIFICATION:
Measurement range: -50°C~150°C or -58°F~+302°F
Resolution: 0.1° for -19.9°~+199.9°, otherwise 1°
Accuracy: ±0.1°C in the range of -30°C~+150°C, otherwise more than
±2°C
±1.8°F in the range of -22°F~+302°F, otherwise more than
±4°F
Am ient temperature for plastic casing:-10°C~+50°C or +14°F~+122°F
Battery: 1x 1.5V “A76” size (LR44, G13) or equivalent
INSTALLATION:
•Unpack the thermometer with care.
•Open the attery door, install the attery into the attery compartment than close the attery
door.
•Sliding plastic sleeve the thermometer is noe ready for use.
•Replace new attery when the low attery indicator appears on the screen.
OPERATION
•Slide/Press the “ON/OFF” switch/Button all functions will show on the display, the thermometer
is ready for use.
•“°F/°C”---to select desired temperature unit.
•“H/T”---press once, “HOLD” flash to retain reading for recording.
•“MAX/MIN”---press once to recall minimum temperature tested. Press again for maximum
temperature tested. Testing mode will restore after 3 seconds
TEMPERATURE ALARM SETTING:
•Press the “LOW Al” or “HI AL” utton for setting alarm at desired low and high temperature.
Press the “LOW AL” utton. The “LOW” sign appears. Press the “HI AL” utton, the “HIGH” sign will
e shown. The display will show -50°C or -58°F and start to increase up to +150°C or /+299°C or
+572°F.

3
•Release the “LOW AL” or “HI AL” alarm set utton when the desired temperature is reached.
The thermometer will normal mode after 3 seconds.
•The alarm will sound in 4 eepings when the measured temperature is greater than maximum or
less than the value.
PRECAUTIONS:
•To o tain the est results, the pro e tip should e immersed at least 10mm into the tested
su stance.
•Make sure the etteries are installed with the correct polarity as shown in the attery
compartment.
•Remove the attery from the attery compartment if the thermometer will not e used for long
duration of time or during storage.
•The thermometer cannot e used or put inside any oven or microwave.
•Place the plastic O-Ring at the appropriate position after opening the attery door to ensure the
waterproof function. (For product with waterproof function only).
•
CHANGING THE BATTERY: