AYRSTONE AyrMesh User manual

Check the contents
of the box:
• AyrMesh Switch
• Power Supply
1Start Here
Ayrstone.com/support
Visit
for detailed instructions,
videos, slide shows, and a
troubleshooting guide
Quickstart Guide – AyrMesh® Switch
2Assemble the Switch
Place the end of the power supply into the
Jack on the back of the Switch
N TE: The AyrMesh Switch is designed for use indoors where it will stay warm
(above freezing) and dry. Do not install it in locations where it may become wet,
too hot (over 120 degrees Fahrenheit) or too cold (under 32 degrees Fahrenheit).
®

D N T F RCE CABLES IN R UT F P RTS!
3Plu in
Power Supply
Plug the power supply into the
wall. The power light on the
front of the switch will come on.
4Connect Ethernet
Cable to Network
Connect any Ethernet port on the
Switch to your network with an Ethernet
cable. It can be connected to your
router, a Remote Hub, a Receiver, an
IndoorAP, or a Bridge Radio.
5Connect Other Devices
Connect the other devices to the Switch with
Ethernet cables. Lights on the front of the unit will
light for each port that is connected to something
“live.” If you have something plugged into a port but
the light on the front is not lit, there is something
wrong with the device or the cable.
N TE: the Switch cannot be used to provide power to
any device – it only provides data connectivity.