Aztech Kyla Smart Smoke Sensor User manual

User Guide

Thanks for using Aztech Kyla product
If you need support or help, please visit www.kyla.aztech.com
Smart Smoke Sensor
01

Product Description
The Smart Smoke Sensor alarms when there is excess
smoke detected indoors. It adopts high-performance
electrochemical sensor, supports sound and flash alarm,
has ultra-low power consumption for longer battery lifespan,
and many other features.
Networking Hole
LED Indicator
Sensor
Base
02

Installation Tips
To increase safety factors in single-layer house, at least a
Smart Smoke Sensor in each bedroom and at 6m from
chimney and gas fixture is suggested.
To increase safety factors in multi-layer house, at least a
Smart Smoke Sensor in each bedroom, in basement, and
at 6m from chimney and gas fixture, is suggested.
Bedroom
Living Room Aisle Kitchen
Basement
Minimum Required Installation
Additional Required Installation
Garage
Bedroom Bedroom
03

Ceiling Mounting
The preferred location to install smoke alarm is in the
centre of the ceiling because smoke, heat, and combustion
products rise to the ceiling and will lateral spread. Keep at
least 30cm distance from lights or decorations, and at
least 15cm away from walls and corner. If hall is more
than 12 meters wide, please install at 2 sides of the hall.
Sloping Ceiling Mounting
If ceiling is sloping, please install the smoke alarm at
horizontal distance 90cm away from the ceiling top.
90cm
Ceiling
Centre
15cm
15cm
04

Operation Guide
Step 1:
Download Aztech Kyla App from Google Play/App Store
Step 2:
Login to Aztech Kyla App, then add “Smart Smoke
Sensor” to device list to enable the device.
Aztech Kyla App
05

Step 3:
Rotate the bracket counter-clockwise from the installation
base, then remove the battery insulating film to turn on
power.
06

Step 4:
Follow the App prompt and press the networking hole
for 2 seconds until a green LED flashes quickly. App will
be prompted once succesfully connected.
(Press the networking hole for 5 seconds to disconnect
from the network. Wait until the green LED flashes slowly
for 3 seconds which indicates that the device has
disconnected successfully.)
07

Step 5:
Remove the double-sided adhesive membrane on the
mounting bracket, and rotate the smoke alarm into
the bracket.
08

Status and Troubleshooting
Red LED flashes
4 times in 10 seconds
Mute Mode Red LED flashes every
10 seconds
Status Light Alarm
Sound
Normal Red LED flashes
every 53 seconds
LED flashes alternately
in 3 colors then go out
No
No
Beeps every
40 seconds
Rapid
Beeps
Beeps Once
Testing
Warm Up
Low Power Red LED flashes every
40 seconds
Beeps every
40 seconds
Fault Red LED flashes every
40 seconds
09