Baños 10 COLUMBIA User manual

23
1
Installation manual COLUMBIA
shower tray
- Check the contents of the product before proceeding to install
(measured, color texture finish, etc).
- Baños 10 is not responsible for the costs of changing the
shower tray when the product is already installed.
- If there is any defect or malfunction on the shower tray it must
be communicated to the company within 7 days.
- Baños 10 is not responsible for any problems there may be due
to improper installation of the shower-tray .
1ELEMENTS SUPPLIED 2ELEMENTS REQUIRED
SILICONE
50
50
50 50
B
A
AB
1) 700
2) 700
3) 700
4) 700
5) 700
6) 800
7) 800
8) 800
9) 800
10) 800
1000
1200
1400
1600
1700
1000
1200
1400
1600
1700
B/2
A/2
- The installation instructions are based on normal use and
conditions.
- These recommendations have been prepared to facilitate and
explain how to install the shower tray. To proceed to install, be
carefully at all times to avoid damage to the shower tray.
- Baños 10 recommends the installation thereof with an installer
Baños 10 Technical Service.
- DO NOT HIT THE SHOWER TRAY. It is a fragile product and
can be damaged.
H = 35 mm.
3IMPORTANT-READ BEFORE INSTALLATION: 4.0 INSTALLATION / NOTES:
- Connect the drain pipe´s shower tray with the drain pipe´s
house.
4.2 INSTALLATION
SAND
- The surface when the shower tray will be located has to be
completely leveled, firm, dry and clean.
4.1 INSTALLATION / PLACE:

Connect the plate and drain pipe and place the dish in its final location
- Connect the shower tray and drain pipe and place it in its
final location.
- Fill the hollow parts of the shower tray with sand before to
proceed to install it.
- Adjust the position of the shower tray and check it is level.
- Securing the position including the two flat edges. Both of
them have to be are close with the wall.
- Press the shower tray to fix completely.
- Install the blezer on the shower tray. Seal all the perimeter
between the shower tray and the wall (use non acetic silicone).
The silicone has to dry completely before to use it.
Check again that the shower tray drains properly.
P-IMP-MAN-173 Gb 1214-3
10 mm
16 mm
COATING
FILLER MATERIAL (Use sand )
DON´T USE CONCRETE!
WALL
FILLED
BONDING
MATERIAL
SECTION OF THE
SHOWER
P-IMP-MAN-173 Gb 1214-3
4.4 INSTALLATION
4.5 INSTALLATION 4.6 INSTALLATION
4.7 INSTALLATION 4.8 INSTALLATION
- After 48 hours you can use the shower.
NOTE:
Do not use solvents or abrasive materials to clean the
shower tray.
To clean the plate using soapy water and a soft cloth,
then rinse thoroughly with warm water and dry it..
- Place the Sikaflex on the floor when the shower tray will be
placed.
SIKAFLEXrange100
4.3 INSTALLATION