BaByliss Turbo Shine 2200 User manual

D570DSDE
Turbo Shine 2200
www.babyliss.com
BaByliss International FZE
Dubai Airport Free Zone (DAFZA)
Building 6EA, Ofce 230/231
P.O.Box: 54831, Dubai, U.A.E.
Year: 2021
Made in China
D570DSDE (S272a)
IB-20/131B

its after-sales service or a similarly
qualied person to avoid a hazard.
•When using the unit, make sure the
unit’s air vent is not blocked. Make
sure there is no hair or any other dirt
obstructing the unit’s rear lter.
•This unit has been equipped with
a temperature cut-out. If the unit
overheats, it will shut off automatically
or will stop heating. If this happens,
slide the switch on the unit’s handle
into the OFF position, unplug the unit
and allow it to cool for 10 minutes.
BEFORE using it again, make sure
there is no hair or any other dirt in
the unit’s rear lter. Plug the unit in
and switch it on. If it overheats again,
stop using it immediately, switch it off
and unplug it. Return the unit to the
BaByliss service centre.
•Do not use the unit if it has fallen or if
it appears to be damaged.
•Do not leave the unit unattended
when it is plugged in or switched on.
•Unplug the unit immediately if you
have problems when using it.
•Do not use any accessories other than
those recommended by BaByliss.
•Unplug the unit after each use and
before cleaning it.
• Avoid any contact between the unit’s
hot surfaces and your skin, in particular,
your ears, eyes, face and neck.
•This unit is not intended for use by
people (including children) with
reduced physical, sensory or mental
capabilities, or by persons who lack
experience or knowledge, unless they
are supervised or have been given
instructions beforehand on the use
of the unit by a person responsible
for their safety. Children should be
supervised to make sure they do not
treat the unit like a toy.
•Allow the unit to cool before storing.
D570DSDE
Read the safety instructions rst.
HOW TO USE
• Towel dry and detangle hair.
• Plug the appliance into a suitable
mains socket.
• Select the required heat and speed
settings.
• After use, switch off and unplug the
appliance.
• Allow the appliance to cool before
storing away.
IMPORTANT! Always keep the rear
of the appliance away from the hair
during use, to prevent it being drawn
in through the rear air lter.
Heat Settings
There are 3 heat and 2 speed settings
plus the cool shot button. Use the
higher heat and speed settings for
initial drying and use the lower heat and
speed settings for styling and scrunch
drying as the hair begins to dry.
Concentrator Nozzle
Use the concentrator nozzle to direct
the airow as you style.
IMPORTANT! Only use the
concentrator nozzle on the lowest
heat/speed setting.
Diffuser
Use the diffuser to enhance natural
curls and create volume.
IMPORTANT! Only use the diffuser on
the lowest heat/speed setting.
CLEANING & MAINTENANCE
To keep your appliance in the best possible
condition, please follow the steps below:
General
•Ensure the appliance is switched off,
unplugged and cool. To clean the
outside of the appliance, wipe with
a damp cloth. Make sure that no
water enters the appliance and it is
completely dry before use.
•Do not wrap the lead around the
appliance, instead coil the lead loosely
by the side of the appliance.
• Do not use the appliance at a stretch from
the power point.
•Always unplug after use.
Cleaning the Filter
• Ensure the appliance is switched off,
unplugged and cool.
•Using a soft brush, gently clean any
hair and other debris from the lter.
SAFETY PRECAUTIONS
• WARNING: do not use
over or near washbasins,
bathtubs, showers or other
containers with water. Store the unit
in a dry place.
•If you are using the unit in a bathroom,
unplug it after you have nished using
it.
•Using the unit close to a source of
water can, in fact, be dangerous,
even if the unit is switched off. To
ensure additional protection, have
installed in your bathroom a residual
current device (RCD) with a nominal
trip current no higher than 30 mA.
Ask your electrical tter for advice.
•Never immerse the unit in water or
any other liquid.
•If the power cord is damaged, it must
be replaced by the manufacturer,
• To prevent damage to the cord, do not
wrap it around the unit and ensure it is
stored without twisting or folding it.
• This unit complies with the standards
recommended by Directives 04/108/
EC (electromagnetic compatibility) and
06/95/EC (safety of domestic electrical
equipment).
END-OF-LIFE ELECTRICAL AND
ELECTRONIC EQUIPMENT
In everybody’s interest and to
participate actively in protecting
the environment:
•Do not discard your products with
your household waste.
•Use the return and collection systems
available in your country.
Some materials can in this way be
recycled or recovered.