Bachmann SWEDX SDS58K8-01-DC User manual

700.4000_Mounting_Instruction_REV01_ENG 1
SWEDX SDS58K8-01-DC
Mounting Instructions
NOTICE: The monitor should be mounted by at least 2 persons.
Bachmann GmbH
Ernsthaldenstraße 33
70565 Stuttgart
Germany
Telefon: [phone]
Telefax: [phone]
E-Mail: [email protected]
Internet: www.bachmann.com

700.4000_Mounting_Instruction_REV01_ENG 2
Mounting Instructions
Step 1: Pull the locking pin and insert the battery module (#700.0000).
Step 2: Switch on the battery and adjust the monitor box to reachable height.

700.4000_Mounting_Instruction_REV01_ENG 3
Step 3: Loosen the screws on the back of the monitor box.
Step 4: Remove the monitor box cover and set it aside.

700.4000_Mounting_Instruction_REV01_ENG 4
Step 5: Pull the locking pin and remove the battery.
Step 6: Hang in the monitor with the pre-assembled adapter rods.

700.4000_Mounting_Instruction_REV01_ENG 5
Step 7: Tighten both screws in the upper region of the monitor box.
Step 8: Tighten both screws in the lower region of the monitor box.

700.4000_Mounting_Instruction_REV01_ENG 6
Step 9: Connect the DC supply cable (#149.0000) with the Docking Station.
Step 10: Pass the DC supply cable through the cable bushing.

700.4000_Mounting_Instruction_REV01_ENG 7
Step 11: Plug the DC supply cable into the monitor.
Step 12: Connect the HDMI cable to the media equipment and monitor.

700.4000_Mounting_Instruction_REV01_ENG 8
Step 13: Fix the cable with cable ties.
Step 14: Sort the cables and cut off cable tie.

700.4000_Mounting_Instruction_REV01_ENG 9
Step 15: Close the monitor box cover.
Step 16: Tighten the screws on the backside of the monitor box.