Baird PM-STRLNK User manual

A
B
ANCHOR THE POLE IN THE GROUND WITH A METHOD SUITABLE
FOR YOUR LOCATION AND SOIL CONDITIONS. (CALL 811 BEFORE
YOU DIG TO LOCATE UNDERGROUND UTILITIES)
PUT A DROP OF THREADLOCKER ON THE THREADS OF THE
BOTTOM SET SCREW AND DRIVE IT IN FLUSH WITH THE OUTSIDE OF
THE SLEEVE. (DRIVE THE SET SCREWS WITH THE INCLUDED 5/32"
ALLEN KEY)
SET THE STARLINK MAST IN THE SLEEVE(MAST SLOT ROTATED 90
FROM THE SET SCREWS). PUT A DROP OF THREADLOCKER ON THE
THREADS OF THE TWO UPPER SET SCREWS. EVENLY TIGHTEN DOWN
THE TWO SET SCREWS TO CLAMP THE STARLINK MAST .
SCAN QR CODE FOR
INSTRUCTIONAL VIDEO
ITEM DESCRIPTION QTY
A INGROUND POLE MOUNT 1
B 5/16"x1/2" LONG SET SCREW 3
C ALLEN WRENCH 5/32" HEX 1
D THREAD LOCKER 1
-
SCALE
BAIRD MOUNTING SYSTEMS
CEDAR FALLS, IA 50613
PHONE: [phone]
[email protected]
PM-STRLNK
PM-STRLNK INSTRUCTIONS
11/15/23
-
HDG STEEL
1OF2 CUSTOMER
PM-STRLNK INSTRUCTIONS
SHEET
DWG. NO.
FINISH MATERIAL
DWG. PURPOSE
DATE
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF
BAIRD SUPPORTING SYSTEMS. ANY REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF BAIRD SUPPORTING SYSTEMS IS
PROHIBITED.
PROPRIETARY AND CONFIDENTIAL
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
ANGULAR: MACH BEND
TWO PLACE DECIMAL
THREE PLACE DECIMAL
DRAWN BY
TITLE:
PART. NO.
WWW.BAIRDMOUNTS.COM
UNLESS OTHERWISE SPECIFIED:
DO NOT SCALE DRAWING

Caution! This product is intended to be mounted on a flat surface and perpendicular to the ground.
FASTENERS MUST BE FIRMLY ANCHORED TO SOLID MATERIALS. Mounting this product on siding and other
uneven surfaces can cause damage to your property and antenna. Baird Mounting Systems, Inc. accepts no
responsibility/liability for damages incurred by improper installation.
Select your installation site with safety, as well as performance, in mind. Remember: ELECTRIC
POWER LINES, PHONE LINES AND GUY WIRES LOOK ALIKE. FOR YOUR SAFETY, Assume ANY
OVERHEAD LINES CAN KILL YOU!
-
SCALE
BAIRD MOUNTING SYSTEMS
CEDAR FALLS, IA 50613
PHONE: [phone]
[email protected]
PM-STRLNK
PM-STRLNK INSTRUCTIONS
11/15/23
-
HDG STEEL
2OF2 CUSTOMER
PM-STRLNK INSTRUCTIONS
SHEET
DWG. NO.
FINISH MATERIAL
DWG. PURPOSE
DATE
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF
BAIRD SUPPORTING SYSTEMS. ANY REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF BAIRD SUPPORTING SYSTEMS IS
PROHIBITED.
PROPRIETARY AND CONFIDENTIAL
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
ANGULAR: MACH BEND
TWO PLACE DECIMAL
THREE PLACE DECIMAL
DRAWN BY
TITLE:
PART. NO.
WWW.BAIRDMOUNTS.COM
UNLESS OTHERWISE SPECIFIED:
DO NOT SCALE DRAWING