Ballard Designs Ashlen LA170 User manual

PRODUCT NAME: Ashlen Table Lamp
ITEM NUMBER: LA170
DIMENSIONS OF ITEM ASSEMBLED: 24 1/4”H x 13” DIA
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE. Page 1 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA
IMPORTANT SAFETY INSTRUCTIONS:
-This Lamp has a polarized plug (one blade is wider than the other) as a feature to reduce the risk
of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fully fit in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an
extension cord unless plug can be fully inserted. Do not alter the plug.
-These Assembly Instructions are provided for your safety. It is important that they are read carefully
and completely before assembling this Lamp.
-This product must be installed with the applicable installation code by a person familiar with the
construction and operation of the product.
-This Lamp has been rated for up to 100 Watt MAX Type A Bulb (NOT Included) or a 25 Watt CFL
Bulb (NOT INCLUDED).
WARNING:
-Deviation from these Assembly Instructions may result in a risk of fire or electric shock.
-To reduce risk of fire, electrical shock, or personal injury, always turn off and unplug Lamp and
allow it to cool prior to replacing the bulb.
-Do not touch the bulb when the Lamp is turned on. Do not look directly at the lit bulb.
-Keep flammable material away from the lit bulb.

NOTE: Remove all parts and hardware from the box along
with any plastic protective packaging and carefully lay all the
parts out on a clean, flat surface.
DO NOT discard any contents until after assembly and
installation is complete to avoid accidentally discarding small
parts or hardware.
Recommended Location for Use: Dry Indoor Environment
Assembly Time: 5 Minutes
People Required: 1 Person
PARTS
Check to make sure you have the following:
WARNING: In accordance with the UL Standard,
to reduce the risk of fire, the Shade should be open
on the top and bottom. The Critical Radius (CR)
should not be less than 3”.
INCLUDED:
Page 2 of 3
Critical
Radius
Shade
NOT INCLUDED:
1- 100 Watt MAX Type A Bulb
OR
1-25 Watt CFL Bulb
1- Lamp Base (A)
1- Lamp Shade (B)
1- Harp (C)
LampBase
Lamp Shade
Harp
1- Finial (D)

Page 3 of 3
STEP 1:
NOTE: Before starting assembly of this Lamp, be sure it has been unplugged.
Turning the switch off is not sufficient enough.
Squeeze the Harp (C) ends into the Saddle of
the Lamp Body (A).
STEP 2:
Place the Shade (B) over the Harp (C) top. Secure
it on top by screwing on the Finial (D) until snug.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning & Care:
To clean, wipe the Fixture with a soft, dry cloth.
Avoid the use of harsh or abrasive
chemicals as they may damage the finish
(A)
(C)
(B)
(D)
(C)
STEP 3:
Screw in the Bulb. This Lamp has been rated for
up to a 100 Watt Max Type A Bulb (NOT Included)
or a 25 Watt Max CFL Bulb (NOT Included).