BaltLED HERONLUX SM User manual

1/2
HERONLUX SM INSTALLATION GUIDE
INSIDE THE BOX
WARNING
•Turn power off before inspection, installation or removal.
•Make sure that all electrical connections are made correctly
before operating the device.
•Installation and start up should only be done by qualified
personnel.
•Cable and luminaire components must be protected against
mechanical impacts and damage.
•Do not operate luminaire with damaged parts.
•For indoor use only.
•Dry location only.
•To prevent wiring damage or abrasion, do not expose
wiring to edges of sheet metal or other sharp objects.
•The manufacturer shall not be liable for any damage
resulting from inappropriate modifications to the
luminaire or faulty installation.
NEEDED FOR MOUNTING
© 2021, All rights reserved BaltLED, UAB. Specifications are subject to change without notice.
If you have any questions, contact the manufacturer.
www.baltled.com
February 19th, 2021
1 2
Seperate lumininare from back plate by twisting it. Bring power cable front of back plate by using hole in the middle.
Strip the wires.
READ THE INSTRUCTIONS CAREFULLY BEFORE STARTING
INSTALLATION
1x Luminaire
3x Plugs
3x Screws

2/2
FULMAR H 120
4
5
HERONLUX SM INSTALLATION GUIDE
© 2021, All rights reserved BaltLED, UAB. Specifications are subject to change without notice.
3
www.baltled.com
February 19th, 2021
Fix the back plate onto the ceiling with 3 screws. Connect power cable to grounded terminal block. Push each terminal’s pin
while putting in the wires to appropriate terminal block’s line.
6
Fix secure wire to the ground hole at grounded terminal block. Connect DC connector between driver and luminaire.
7Install luminaireto back plate and twist to fix.