BARCALOUNGER Galloway User manual

USE AND CARE GUIDE
Item # 171-409-REC-KD-LS
Item # 171-409-REC-KD-SI
Questions, problems, missing parts? Before returning to the store,
call Our Customer Service
8.00 a.m. - 5.00 p.m. EST, Monday - Friday
888-445-6690
[email protected]
Ver: 1-19-2021
Galloway Cushioned Fully Woven Recliner

Safety Information
DANGER: Please keep children out of the assembly area
during assembly. CAUTION:
Care and Maintenance
Contents
Warning and Cautions
Assembly...................................... ................................. 4
Care and maintenance ...............................................2
Warning and Cautions..................................................2
3Part list............................................................................
2
Do not machine wash or tumble dry, as the cushions may shrink.
FRAME
To clean frame, use mild soap and water. Do not use abrasive materials, cleaners or products containing bleach.
Rinse with clean water and dry thoroughly.
To maintain frame, clean thoroughly and let it dry. Drain any water that may have collected inside the frame.
Water not drained and exposed to freezing temperaturres may cause damage to the frame tubing.
Prior to storing, be sure to clean and thoroughly dry.
FABRIC
Sunbrella fabric should be cleaned regularly. Brush off any loose dirt and wash with a mild soap and lukewarm
water solution. For stubborn stains and mildew, wash with a solution of 236 ml / 1 cup of bleach and 59 ml /1/4 cup
of mild soap per 3.8 l / 1 gallon of water. To protect your skin, please remember to wear rubber gloves.
Rinse thoroughly to remove soap. Allow fabric to air dry.
®
IMPORTANT: IMPORTANT:
You must lubricate
the key points ( ) of
the reclining mechanism
with silicon at least every
12 months.
RECLINING MECHANISM
Operation......................................................................... 5
Disassembly.....................................................................5

3
Part List
PACKAGE CONTENTS
AB
C
Part Description
A Chair base
BBack panel
CBack cushion
D Seat cushion
D
Quantity
1
1
1
1
Use two people to assemble. Please lay out all parts prior to assembly, to verify all parts are included.

Assembly
1Attaching the back panel
2Placing cushions
□
□
□
Place the chair base (A) on a flat, smooth surface.
4
□Level the chair with foot glides at the bottom of chair legs if necessary.
Place cushions (C) and (D) on the chair.
□
□
Hold the back panel (B) close to the rear support bars (1) of
the recliner mechanism.
Adjust the gap between the two support bars (1) to match
the gap between two slots (2) on the back panel. (Step 1.1)
Slide the two support bars (1) into the two slots (2)
until two audible clicks are heard. (Step 1.2)
1
2
A
BStep 1.1
Step 1.2
C
D

Operation
5
IMPORTANT: You s IMPORTANT:
Using the lounge chair on hard surface like cement floor, wooden deck, tiles and etc. is recommended.
There is a reclining mechanism inside the lounge chair.
Using the lounge chair on soft surface like grass, leaves or sand will possibly fail the mechanism.
Rain water will influence the functionality of the reclining mechanism.
IMPORTANT: IMPORTANT:
DO NOT leave the lounge chair outdoors when not in use. The frame should be stored
away from rain, snow / ice.
Disassembly
IMPORTANT: IMPORTANT:
DO NOT disassemble the chair unless you have to.
Mind your fingers while moving chair parts.CAUTION :
Lift the pins (3) on both slots at the same time.
With one foot stepping on the seat panel of the chair base ,
pull the back panel upward to detach the support bar (2) of the reclining mechanism
from the slots (1) of the back panel.
31
2
IYou s WARNING:
Do not put hands inside of recliner at any time to avoid pinching fingers or injury to hands.