Battery Tender 030-0004 User manual

Battery Booster Pack
Instruction Manual
DO NOT EXPOSE TO WATER, FIRE, OR SMOKE
RECHARGE UNIT WHEN FIRST USED, AFTER EACH
USE & EVERY 3 MONTHS!
Important: Please ensure that you read and save this instruction manual before
using this product. Incorrect operation or misuse of this Battery Booster Pack may
damage the equipment or create hazardous conditions for the user. SAVE THESE
SAFETY INSTRUCTIONS FOR FUTURE USE.
Conventions Used
The following conventions are used in this manual:
WARNING
Warnings identify conditions that could result in personal injury or loss of life.
CAUTION
Cautions identify conditions or practices that could result in damage to the unit or to other
equipment.
NOTE
Describes an important action item or an item that requires attention.
Abbreviations and Acronyms
A Ampere
AC Alternating Current
Ah Amp-hours
DC Direct Current
mA Milli-Ampere
V Volt
LED Light emitting diode
for P/N 030-0004
P/N 392-0372-R0

1 2
CONTENTS
Introduction………………………………………...…………………………………… 2
Important safety instructions ………………………………………………………… 2
Features ………………………………………..…………….………………………… 3
Operations …………………………................................…………………………… 5
Recharging ………………...…...…………….................................…………………6
12V DC accessory outlet …................................….………………..……………… 6
Maintenance and Care.......................................……………….....…………………7
Troubleshooting ……………………………................................……………………8
Specifications ……………………………................................………………………8
1. Introduction
Easy to use and designed for reliable service, the Battery Booster Pack can
Jump start cars, light trucks, motorcycles, ATVs, lawn tractors and more
Power 12 V DC accessories and USB accessories
2. Important Safety Instructions
The Battery Booster Pack generates a high current to the battery being boosted.
Operating the Battery Booster Pack incorrectly or misusing it may damage
the equipment or create hazardous conditions for the user.
NOTE: Ensure that you read and understand these safety instructions before using
the Battery Booster Pack.
CAUTION:
The unit is not intended for use as a UPS (Uninterrupted Power Supply).
WARNING:
Before starting the vehicle, ensure that the clamps are connected in the right way and the
green indicator light is on.
WARNING:
The Battery Booster Pack contains components that tend to produce arcs or sparks. To
prevent the risk of fire or an explosion, do not operate the Battery Booster Pack in
compartments containing batteries or flammable materials, or in locations that require
ignition-protected equipment.
WARNING: Fire Hazard
Never allow the red and black clamps to touch each other or another common metal
conductor. This could cause damage to the unit and/or create a sparking/explosion hazard.
WARNING:
The cable clamps connecting the boosting cables to the vehicle’s battery terminals must be
positive to positive (red clamp to battery “+”) and negative to the engine block, cylinder
head, or other stationary heavy metal part of the motor. A reverse polarity connection
(positive to negative) may cause damage to the unit and/or create a sparking/explosion
hazard.
Warranty ……………………………................................……………………........…9

3 4
WARNING: Fire hazard
The jump start feature is designed for short term operation only—less than 2-3 seconds.
Operating the jump start feature for more than 3 seconds may cause damage to the unit.
Allow the Battery Booster Pack to cool down for at least 3 minutes after each jump start .
WARNING:
Do not charge the unit through the 12VDC socket!
WARNING:
Ensure that there are no 12VDC appliances connected to the Battery Booster
Pack while the unit is being recharged.
3. Features
(5) Reverse/Incorrect Connection Indicator – Red LED indicates when the battery clamps
are reversed or improperly connected to the battery (vehicle battery voltage over 2.5V).
(4) Correct Connection Indicator – Green LED indicates when the battery clamps are
properly connected (vehicle battery voltage over 2.5V).
(7) Charging indicator: Red LED indicates when the unit is being recharged, when it turns
to green, the unit is fully charged.
(1) Battery status button – When pressed, LED indicator displays level of charge left in
the battery and determines if the unit needs to be charged. See item (2) for details.
(6) AC charging jack – Use the included external AC charger to recharge the unit through
this charging jack. Only use the suppliled AC charger to charge this unit.
(9) LED light switch – Slide it to turn on or turn off the emergency light.
(3) Emergency LED light.
(8) 12V DC power port – Easy-access port for powering a variety of 12V accessories.
(11) USB port – It provides 5V USB power for electronic devices.
(10) USB switch – Slide the switch to turn USB power on or off.
(12) USB on indicator – When USB power is on, this green LED indicator will illuminate.
(14) On/Off Switch – When jump starting a vehicle, ensure this switch is in the “off” position
before connecting the unit to the vehicle battery. Once properly connected, the unit should
be switched to the “on” position.
(13) Boosting cables – These cables connect clamps and Booster Pack.
(15) 15A Fuse – 15A over current protection for 12V DC outlet.
WARNING:
Before starting the vehicle, ensure that the clamps are connected in the right order and the
green indicator light is on (vehicle battery voltage over 2.5V).
CAUTION:
The unit is not intended for use as an UPS (Uninterrupted Power Supply).
(2) Battery level LED indicator – Identifies the level of charge remaining in the internal
battery. When the 3rd (green) LEDs light up, the unit is over 75% charged. When the 2nd
(yellow) LEDs light up, the unit is about 50% charged and should be recharged. When the
1st (red) LED lights up, the unit is only 25% charged and needs recharging immediately.
21
98
56
11
12 13
10
74
3
14 15
13

4. Operating Instruction
5 6
The unit should be operated only in locations that meet the following requirements:
(1) Dry Do not allow water or other liquids to drop on or splash the unit.
(2) Cool Ambient air temperature should be between 0 and 40°C (32 and 104 °F)–
the cooler the better within this range.
(3) Ventilated Leave at least 2” (5 cm) clearance around the Battery Booster Pack for
air flow. Ensure that the ventilation openings are not obstructed.
(4) Safe Do not operate the unit in enclosed areas where batteries may be stored
or in any compartment capable of storing flammable liquids like gasoline.
(5) Protected Do not operate the unit where it will be exposed to battery gases. These
gases are very corrosive and prolonged exposure will damage the Battery
Booster Pack.
NOTE:
Closely follow these instructions for jump starting a vehicle as they may be different from
the instructions supplied with other boosting products or boosting cables.
Jump starting procedures
(1). Turn off the vehicle and all accessories.
(2). Place the Battery Booster Pack on a flat and stable surface near the battery which
needs to be started. Ensure that the Booster Pack power switch is “OFF”.
(3). Connect the red positive (+) clamp of the cables to the positive (+) terminal of the
engine battery.
(4). Connect the black negative (-) clamp of the cables to the engine block, cylinder
head, or other stationary heavy metal part of the stalled vehicle. If the red “Battery Clips
Incorrect” LED illuminates, then reverse polarity has been detected. Correct polarity must
be established before proceeding. Disconnect the boosting clamps from the vehicle’s
battery and repeat steps (3) and (4).
Note: if vehicle battery voltage is less than 2.5V, LED will not turn on, but you still can
jumpstart.
(5). Turn the power switch on. Before starting the engine, make sure the Booster Pack and
the cables are clear of metal parts and other moving objects.
(6). Start the engine for 3 seconds or until it starts, whichever is first.
WARNING: Fire hazard
Do not try starting the engine for more than 3 seconds. The boosting feature is designed for
short term operation only. Operating the boosting feature for more than 3 seconds may
cause damage to the unit. Allow the Battery Booster Pack to cool down for at least 3
minutes after each boost.
(7). Turn the power switch off.
(8). Disconnect both clamps in reverse order and place them back in the holders.
5. Recharging
NOTE:
Recharge the Battery Booster Pack as soon as possible after each use.
When the Battery Booster Pack is not being used, it should be recharged every 3 months!
WARNING:
Must not be recharged through the 12V DC socket.
WARNING:
Make sure that there is no 12V DC appliance connected to the Battery Booster Pack
during charging.
Recharging using an AC charger
(1) Turn the rotary switch to the off position.
(2) Plug the 120V AC charger into the charger input socket on the Booster Pack.
(3) Plug the 120V AC charger into the 120 V AC electrical socket.
(4) Do not stop until the battery is fully charged. This should take about 40 hours.
NOTE:
Charging time for the Battery Booster Pack is 40 hours assuming that the voltage in the AC
wall outlet is 120V. If the voltage is less than 120V AC, it may take longer than 40 hours to
fully charge.
NOTE:
Once fully charged, the charging current automatically drops to a floating charge mode,
and the unit may be left permanently connected to the AC charger.
6. 12V DC outlet
For optional 12V power accessories using a cigarette plug. Use the portable power outlet
for power supply for fishing and camping trips, extended running of mobile phones,
camcorders, computers, etc. Combining the unit with an inverter provides 120V AC power.
NOTE:
12V cigarette plug is not supplied with this unit.
It is recommended that you do NOT power accessories that draw more than 8 Amps.
Ensure the cigarette adapter you are using is properly rated.

7 8
7. Maintenance and Care
Routine maintenance is required to keep your Motomaster Booster Pack operating
properly. Occasionally clean the exterior of the unit to remove dust and dirt.
SHOCK HAZARD.
Disconnect all sources of AC power and DC power before performing any type of
maintenance.
Battery Maintenance
You need to recharge the battery periodically to maintain maximum battery capacity and to
avoid gradually discharge when left standing.
INTERNAL BATTERY DAMAGE.
Due to inherent self-discharge, lead-acid batteries must be charged at least every 3
months, especially in a warm environment. Leaving a battery in a discharged state, or
failing to recharge every 3 months, may result in permanent battery damage and poor
performance.
INTERNAL BATTERY DAMAGE.
Gradually warm the frozen battery to 0°C (32°F) before recharging to avoid battery
damage.
Battery Recycling
The jumpstarter is designed to provide years of service. However, the internal battery is not
designed to be user replaceable.
Because the internal batteries contain lead, which can be hazardous if exposed to the
environment, the battery should be recycled or safely disposed of at your local recycling
depot. Do not dispose of the battery and the jumpstarter with common household waste.
Please ask your local authorities about recycling services that are available in your area.
8. Troubleshooting
9. Specifications
Problem
The engine being
jumpstarted will not
start.
Battery Booster
Pack does not
recharge.
The appliance
plugged into the
outlet does not work.
The Battery Booster Pack battery
is not fully charged.
Charge it for at 40 hours.
Mechanical Problem Auto Shop
Bad Connection Reconnect and rock back and
forth
Battery Booster Pack battery has
been damaged.
Replace the unit.
Accessories are connected to the
12V DC socket.
Disconnect the accessories.
120V AC charger may be
damaged.
Replace 120V AC charger
Not charged after previous use. The battery may be damaged
as it may not have been
recharged after previous use.
Battery has discharged to 10V. Recharge the Booster Pack.
Fuse might be blown. Replace fuse.
The appliance power is over
standard.
Use an appliance where the
power is lower than 15A.
Cause Solution
Internal battery (Capacity/Type)
Jump start cables (Size/Length)
Adapter
Cigarette lighter plug maximum current
Dimensions L x W x H
Operating temperature range
6G*30”
15V DC@800 mA
15A
11½ x 7½ x 9½
0°C −40°C(32 −104 °F )
18Ah (AGM) sealed lead-acid battery

9 10
10. Warranty
The Battery Booster Pack comes with a twelve (12) month limited warranty
against defects or failure within one (1) year from purchase.
THIS LIMITED WARRANTY IS VOID under the following conditions:
1) The product is misused, subjected to careless handling, or operated under conditions of
extreme temperature, shock, or vibration beyond our recommendations for safe and
effective use.
2) The product is disassembled or repaired by anyone who is not a factory authorized
service representative.
3) The product was purchased from an unauthorized source. Warranty is not transferable
from original purchaser.
4) Any physical damage to the Battery Booster Pack or any accessories occurring
after purchase.
5) Any modifications to the Battery Booster Pack or accessories.
6) Any corrosion including salt water.
DISTRIBUTED BY:
DELTRAN USA LLC.
801 International Speedway Blvd.
Deland, Florida 32724
[phone]