Baumatic BDW2W User manual

1

2
Installation steps

3

4

5

6

7
TD series timer circuit diagram

8
TD series timer wiring diagram

9

10

IMPORTANT!
PLEASE READ THIS MANUAL AND KEEP IT FOR FUTURE REFERENCE!
THIS MANUAL CONTAINS SECTIONS OF SAFETY INSTRUCTIONS, OPERATING INSTRUCTIONS
& TROUBLESHOOTING TIPS, ETC.
BAUMATIC
BDW2W / BDW2SS DISHWASHER
60CM FULL HEIGHT DISHWASHER
INSTRUCTION MANUAL

BAUMATIC
PLEASE NOTE:
THE MANUFACTURER
RESERVES THE RIGHT TO MAKE
MODIFICATIONS TO PRODUCTS
WITHOUT GIVING PRIOR NOTICE.
CONTENTS
SAFETY FIRST!
Please read this before using your dishwasher!
KNOWING YOUR
DISHWASHER
USING YOUR DISHWASHER
BEFORE YOU CALL FOR
SERVICE…
MISCELLANEOUS

BAUMATIC
READ BEFORE USING!
NEVER USE SOLVENTS AS THIS COULD RESULT IN AN
EXPLOSION!

BAUMATIC
CONTROL PANEL
1
2
3
4
5
6
7
8
DISHWASHER FEATURES

BAUMATIC
WARNING!
ONLY USE DISHWASHER SALT IN YOUR
DISHWASHER.
NOTE:
IF YOU USE 3-IN-1 OR 2-IN-1 TABLETS, BE
SURE NOT TO ADD SALT AND/OR RINSE AID
TO THE APPLIANCE AS THESE TABLET
TYPES ALREADY CONTAIN SALT AND/OR
RINSE AID. ADDING SALT AND RINSE AID
TO YOUR DISHWASHER’S COMPARTMENTS
IN A CYCLE INVOLVING A 3-IN-1 OR 2-IN-1
TABLET WILL RESULT IN OVERDOSING OF
INDIVIDUAL CHEMICALS AND MAY CAUSE
OVERFLOWING OF WATER AND SUDS.
LOADING SALT INTO THE SALT CONTAINER
Note on chemicals used by the dishwasher
Your dishwasher is equipped with an adjustable rinse aid and salt container. Using individual detergents,
rinse aid and salt will give the best possible results as this will give the correct dosage of each chemical to
suit your needs. Using Two-in-One or Three-in-One tablets may not give the best results when used in
your appliance, and may not be suitable for the type of water supply in your home, as they contain
pre-determined quantities of salt, rinse aid and detergent and cannot be adjusted to the individual
requirements.
If you are going to use 3-in-1 (or 2-in-1) tablets, we suggest that you contact the manufacturer before use or
if you experience poor results in the wash performance and ask for assistance from them.

BAUMATIC
SETTING THE WATER SOFTENER LEVEL
NOTE
1. THE SALT CONTAINER MUST BE REFILLED WHEN THE
SALT WARNING LIGHT COMES ON. ALTHOUGH THE
SALT CONTAINER MAY BE FULL, THE INDICATOR LIGHT
MAY NOT GO OUT UNTIL THE SALT HAS DISSOLVED.
2. IF THERE ARE SALT SPILLS, A SOAK PROGRAM CAN
BE RUN TO WASH AWAY SPILLAGE BEFORE USING THE
MACHINE.
3. CLEAR ANY SALT GRANULES AWAY FROM THE
CONTAINER OPENING.
WATER H ARDNESS
Clarke Degrees dH mmol /l Sel ect or Po siti o n Salt consumption
(gra m/cycle)
Au to nomy
(cycles/1.2kgs)
0~14 0~18 0~ 1. 8 /0/
14~36 18~44 1.8~4.4 -20 60
36~71 44~89 4. 4~8.9 MED 40 30
71 89 8. 9 +60 20
Contact your local water board for information on the hardness of your water supply.
How much do I use?”
*NOTE: SEE P.13 – WASH CYCLE TABLE for AMOUNT of DETERGENT to use

BAUMATIC
THE RINSE AID IS RELEASED DURING THE
FINAL RINSE TO PREVENT WATER FROM
FORMING DROPLETS ON YOUR DISHES THAT
CAN CAUSE SPOTS AND STREAKS. IT ALSO
IMPROVES DRYING BY ALLOWING WATER TO
FALL OFF THE DISHES.
YOUR DISHWASHER IS DESIGNED TO USE
LIQUID RINSE AIDS. THE RINSE AID
DISPENSER CAN BE FOUND INSIDE THE
DOOR NEXT TO THE DETERGENT DISPENSER.
TO FILL THE DISPENSER, OPEN THE CAP AND
POUR THE RINSE AID INTO THE DISPENSER
UNTIL THE LEVEL INDICATOR TURNS
COMPLETELY BLACK. THE DISPENSER
HOLDS ABOUT 100ML OF LIQUID RINSE AID.
BE CAREFUL NOT TO OVERFILL THE
DISPENSER – THIS COULD CAUSE FROTHING.
WIPE AWAY SPILLS WITH A DAMP CLOTH.
DON’T FORGET TO REPLACE THE CAP
BEFORE YOU CLOSE THE DISHWASHER
DOOR.
NOTE: IF YOU HAVE SOFT WATER, YOU MAY NOT
NEED RINSE AID FOR IT MAY CAUSE A WHITE FILM TO
DEVELOP ON YOUR DISHES.
ADJUSTING THE RINSE AID DISPENSER
As the rinse aid diminishes, the size of the black dot on the rinse
aid level indicator changes, as illustrated below.
Full
3 / 4 full
1 / 2 full
1 / 4 full - Should refill to eliminate spotting
Empty

BAUMATIC
BEFORE LOADING!
NOT :

BAUMATIC
HOW TO USE THE UPPER RACK
LOADING GUIDE (UPPER RACK)
1
2