Baxi Barselona User manual

Baxi Barcelona
Wall Mounted Powered Flue Condensing Boiler
Gas Fired Central Heating Unit
User’s Operating
Instructions
Please keep these instructions safe.
Should you move house, please hand
them over to the next occupier.

2
Baxi UK Limited is one of the leading manufacturers
of domestic heating products in the UK.
Our first priority is to give a high quality service to our
customers. Quality is designed into every Baxi product
- products which fulfil the demands and needs of
customers, offering choice, efficiency and reliability.
To keep ahead of changing trends, we have made a
commitment to develop new ideas using the
latest technology - with the aim of continuing to
make the products that customers want to buy.
Baxi is also the largest manufacturing partnership in
the country. Everyone who works at the company has
a commitment to quality because, as shareholders, we
know that satisfied customers mean continued
success.
We hope you get a satisfactory service from Baxi. If
not, please let us know.
Natural Gas
Baxi Barcelona
G.C.No41 075 02
Baxi is a BS-EN ISO 9001
Accredited Company
The boiler meets the requirements of Statutory Instrument
“ The Boiler (Efficiency) Regulations 1993 No3083” and is
deemed to meet the requirements of Directive 92/42/EEC
on the energy efficiency requirements for new hot water
boilers fired with liquid or gaseous fuels:-
Type test for purpose of Regulation 5 certified by:
Notified Body 0086.
Product/Production certified by:
Notified Body 0086.
For GB/IE only.

1.0 Warnings
3
1.1 Safe Installation
1. The installation must be carried out by a CORGI
Registered Installer or other registered competent
person and be in accordance with the relevant
requirements of the current GAS SAFETY
(Installation and Use) REGULATIONS, the BUILDING
REGULATIONS (Scotland)(Consolidation), the LOCAL
BUILDING REGULATIONS, the current I.E.E. WIRING
REGULATIONS and the bye laws of the LOCAL WATER
UNDERTAKING. Where no specific instruction is
given reference should be made to the relevant
BRITISH STANDARD CODES OF PRACTICE.
For Ireland install in accordance with IS 813
“INSTALLATION OF GAS APPLIANCES”. Reference
should also be made to BRITISH GAS GUIDANCE
NOTES FOR THE INSTALLATION OF DOMESTIC GAS
CONDENSING BOILERS.
2. This appliance must be installed in accordance
with the manufacturer’s instructions and the rules
in force, and only used in a suitably ventilated
location.
3. Read the instructions before installing or using
this appliance.
4. Any purpose provided ventilation should be
checked periodically to ensure that it is free from
obstruction.
IMPORTANT - The addition of anything that
may interfere with the normal operation of the
appliance without the express written
permission of Baxi UK Limited could invalidate
the appliance warranty and infringe the GAS
SAFETY (Installation and Use) REGULATIONS.
1.2 In case of gas leaks
1. If a gas leak is found or suspected, turn off the
gas supply at the meter immediately and at the
isolating valve on the boiler if possible. Contact your
Installer or Transco (under 'Gas' in the phone
directory). Do not operate any electrical equipment
or light switches.
1.3 Servicing your Appliance
1. For reasons of safety and economy your appliance
should be serviced annually. Your Installer or British
Gas Service will be able to advise you.
1.4 Electricity Supply
1. THIS APPLIANCE MUST BE EARTHED.
2. A standard 230V ~ 50Hzsupply is required. The
appliance must be protected by a 3 amp fuse.
Never Hang Flammable Items Over
The Appliance
B.S. Codes of Practice
Standard Scope
BS 6891 Gas Installation.
BS 5546 Installation of hot water supplies for
domestic purposes.
BS 5449 Part 1 Forced circulation hot water systems.
BS 6798 Installation of gas fired hot water boilers.
BS 5440 Part 1 Flues.
BS 5440 Part 2 Ventilation.
BS 7074 Expansion vessels and ancillary
equipment for sealed water systems.
BS 7593 Treatment of water in domestic hot water
central heating systems.
“Benchmark”Installation, Commissioning and Service Record
Log Book
Please ensure that your installer has completed the Installation and
Commissioning sections of the Log Book and hands the Log Book over.
The details of the Log Book will be required in the event of any warranty
work. Keep the Log Book in a safe place and ensure that the relevant
sections are completed at each subsequent regular service visit.
All CORGI registered installers carry a CORGI identification card
and have a registration number. Both should be recorded in your
boiler Log Book. You can check your installer is registered by
telephoning 01256 372300 or writing to:-
1 Elmwood,
Chineham Business Park,
Crockford Lane,
Basingstoke.
RG24 8WG.

2.0 Operating the Boiler
4
2.1 Operating the Boiler
1. Remove the lower door panel by gripping it’s
lower edge and rotating upwards (Fig. 1).
2. Turn on the main gas and electricity supplies
to the appliance.
3. Set the boiler thermostat control knob to the
required setting (Fig. 3). (The optimum boiler
setting depends upon type of system, external
controls and your requirements. Your installer will
be able to advise you on this matter.)
4. The fan will start to run and after a short period
the ignition spark will commence. Sparking will
continue until the flame is established then stop
automatically. Check that both the mains ON light
and boiler ON light are on. Mains ON is indicated
by green and boiler ON by yellow (Fig. 2).
5. Flashing mains ON light indicates that there is
a mains electrical supply to the boiler, but the
control knob is in the OFF position. Turn the
control knob on and ignition will start.
2.2 To shut down the Boiler
1. Turn off the electricity supply to the appliance
at the mains.
2. Turn the boiler thermostat control knob to OFF
““(Fig. 4), then turn off the gas supply at either
the appliance gas cock or the meter.
2.3 Frost Protection
1. The boiler does not have integral frost
protection. It is recommended that the installer
fits a suitable protection device to the system
controls if required. For frost protection the boiler
must be turned on.
2.4 In Operation
1. The Barcelona is a high efficiency “condensing
boiler”. In common with other condensing boilers
its exceptional efficiency means the flue gases
are cooled to such an extent that steam is often
visible at the outside flue terminal. The amount
produced depends on system design, product
use and outside air temperature but it is not
harmful to the individual or the working of the
appliance in any way.
HIGH
LOW
Lower Door Panel
HIGH
LOW
HIGH
LOW
Fig. 1
Fig. 3
Fig. 4
HIGH
LOW
Boiler Thermostat
Control Knob
Mains ON
(Green)
Boiler ON
(Yellow)
Overheat
or Lockout
(Red)
Fig. 2
HIGH Position
OFF Position

3.0 Safety Devices
5
3.1 Operation of Safety Devices
1. Your Baxi Barcelona is fitted with safety
devices which shut down the appliance if:
a) the system overheats.
b) the condensate drain is blocked.
c) there is no gas to the boiler.
2. The lockout indicator light will be either flashing
or permanently illuminated and the boiler will need
resetting (Fig. 6).
NOTE: In the case of persistent operation of
the devices, turn off the boiler and consult your
service engineer as an appliance or system
fault is indicated.
3.2 Resetting
1. Allow the boiler to cool if hot.
2. Remove the lower door panel by gripping it’s
lower edge and rotating upwards (Fig. 5).
TO RESET THE BOILER if the lockout indicator
light is flashing once a second, follow these
instructions.
3. Turn the boiler thermostat control knob fully
anti-clockwise to the OFF position marked ““
(Fig. 7).
4. Wait 10 seconds.
5. Turn the boiler thermostat control knob
clockwise to the required thermostat setting, the
overheat light will go out and the boiler will fire up
automatically when it has sufficiently cooled.
TO RESET THE BOILER if the lockout indicator
light is permanently illuminated, follow these
instructions.
6. Check that the gas supply to the appliance has
not been inadvertantly turned off.
7. Check the condensate drain outlet has not
been blocked.
WARNING: The condensate outlet must not be
blocked or modified.
8. Turn the boiler thermostat control knob fully
anti-clockwise to the OFF position marked ““
(Fig. 7).
9. Wait 10 seconds.
10. Turn the boiler thermostat control knob
clockwise to the required thermostat setting, the
overheat or lockout light will go out and the boiler
will fire up automatically.
HIGH
LOW
Boiler Thermostat
Control Knob
Mains ON
(Green)
Boiler ON
(Yellow)
Overheat
or Lockout
(Red)
Fig. 6
HIGH
LOW
Fig. 7 OFF Position
HIGH
LOW
Lower Door Panel
Fig. 5

4.0 Clearances
6
4.1 Clearances around the Boiler
(Figs. 8 & 9)
1. The minimum clear spaces needed around
the boiler are:
Top - 200mm
Bottom - 130mm
Both sides - 5mm
Front - 500mm (For Servicing)
- 5mm (In Operation)
2. The boiler may be installed in a cupboard if
these minimum clearances are kept and
permanent ventilation to the boiler is provided in
the compartment. The sizes of the ventilation
opening at high and low levels are as follows:
3. These clearances and vents must not be
obstructed in any way. Blocking these will
result in the boiler overheating and possible
damage may occur.
4. The compartment should be large enough to
house the boiler and ancillary equipment only.
5. IT SHOULD NOT BE USED AS A STORAGE
CUPBOARD.
6. The gas burning compartment of your boiler is
completely sealed from the room in which it is
fitted. Products from the combustion of gas are
vented to the outside through the flue terminal
which must be kept free from obstruction as this
would interfere with the correct operation of the
boiler.
7. The condensate drain must not be blocked or
modified.
130mm
600mm
390mm
200mm
5mm Min
5mm Min
5mm
500mm
For Servicing
Purposes
Fig. 8
Fig. 9 In Operation
3°
320mm
Position of Air from Air direct
Air Vent Room from Outside
High 306cm2(49 in2) 153cm2(24.5in2)
Low 306cm2(49 in2) 153cm2(24.5in2)

5.0 Cleaning, Spares & Guarantee
7
5.1 Cleaning the Outercase
The painted panels should be wiped with a damp
cloth and then dried completely. DO NOT USE
ABRASIVE CLEANING AGENTS.
5.2 Spare Parts
Repairs should be carried out by a CORGI
Registered Installer or other Registered Person
1. Any repairs to the boiler will usually be the
responsibility of the Installer during the
guarantee period after which spare parts may be
obtained through approved Baxi stockists if
required.
2. Quote the appliance name, model number
(found on the reverse of the lower door panel)
and where possible the part number when
ordering spares. A short parts list is included in
the Installation and Servicing Instructions.
5.3 Guarantee
1. Your Baxi Barcelona is designed and
produced to meet all the relevant Standards.
2. Baxi UK Limited provide a 12 month
guarantee on the boiler. The guarantee operates
from the date installation is completed for the
customer who is the original user.
3. To maximise the benefit from our guarantee
we urge you to return the reply-paid guarantee
registration.
4. This does not in any way prejudice your rights
at Common Law. Such rights between the
customer and the installer or supplier from whom
the unit was purchased remain intact.
Any component or part which becomes
defective during the guarantee period as a
result of faulty workmanship or material
whilst in normal use will be repaired or
replaced free of charge.

Baxi UK Limited
Brownedge Road
Bamber Bridge Preston
Lancashire
PR5 6SN
www.baxi.com
After Sales Service
08706 096 096
Comp No240817 - Iss 4 - 10/00