Baxton Studio 7232T User manual

MODEL : 7232T
ASSEMBLY INSTRUCTION
PART LISTNO QTY
ATABLE TOP
BPEDESTAL TABLE CENTER
1 PC
C
CROSS BAR 'X' 2 PCS
Read this instruction carefully. Remove all wrapping material, staples and straps
from the carton. See hardware and furniture part list For guidance. Be sure you
have all wooden furniture parts on a clean and flat soft surface, such as a carpet or
rug, to prevent from being scratched.Follow the figure to start assembling.
CAUTION :
1. Do not FULLY - TIGHTEN the nut or screw untill all is ready to assemble.
2. Do not OVER - TIGHTEN the nut or screw to avoid causing damages
to the thread.
3. Keep all hardware part out reach of children.
1 PC
D
PEDESTAL LEGS 4 PCS
STEP 1 STEP 2
STEP 3 STEP 4
COMPELETE
ASSEMBLE
DESRIPTIONNO QTY
1
2
3
4
16 PCS
8 PCS
CSK SCREW M4 X 30MM
FLAT WASHER
5
1 PC
SPANNAR
HEX. NUT 8 PCS
4 PCS
ADJUSTER
C
B
4
2
3
C
C
C
B
D
C
1 X 8PCS
A
C
5
5
5
5
C
1X 8PCS
D

ASSEMBLY INSTRUCTION MODEL : 338C
Read this instruction carefully. Remove all wrapping material, staples and straps from the
carton. See hardware and furniture part list
For guidance. Be sure you have all wooden furniture parts on a clean and flat soft surface,
such as a carpet or rug, to prevent from being scratched.Follow the figure to start assembling.
CAUTION :
1. Do not FULLY - TIGHTEN the nut or screw untill all is ready to assemble.
2. Do not OVER - TIGHTEN the nut or screw to avoid causing damages to the thread.
3. Keep all hardware part out reach of children.
PART LISTNO QTY
ABACK REST
BFRONT LEG
CSIDE RAIL 2 PCS
DWOODEN SEAT WITH SCOOP 1 PC
1 PC
1 PC
5
1
4
DESRIPTIONNO QTY
1
2
3
4
5
JCBC SCREW M6 X 50MM
WOOD DOWEL Ø8 x 30MM
CSK SCREW M4 x 30MM
SPRNG WASHER M6
M4 ALLEN KEY
6 PCS
4 PCS
3 PCS
6 PCS
1 PC
COMPELETE ASSEMBLE
STEP 1
Attached C to B according to
the hole and tighten it using
hardware number 1,2,4, and 5 .
C
C
B
2
4
1
5
STEP 2
Align the whole part from STEP1
to A . Tighten the part of C and
A using hardware number 1,4
and 5 .
C
A
STEP 3
Stick D to the whole assemble
part and fully-tighten it with
hardware number 3 .
STEP 4
C
A
D
3 X 3PCS