Baxton Studio ETAN-004 User manual

1
2
A8 PCS
8 PCS
1 PCS
1 PCS
8 PCS
4 PCS
4 PCS
4 PCS
2 PCS
B
C
G
H
I
J
D
E
F
1
2
3
4
5
6
7
8
6
10
CL DL DR CR
K8 PCS
8 PCS
6
7
8
6
A
A
AAC
DD
G
G
G
G
C
DD
Attach the handle (C) using screw (D) & cam bolt (A) on piece 6.
Attach pieces 7, 8, & 9 using screws (G).
Make sure that the built-in ridge is facing inwards and at the bottom.
10
7
6
B
B
B
B
7
10
88
Slot piece 10 into the ridges. First insert the cam locks (B) into the pre-drilled holes on parts 7 & 8.
Line up these screws with the pre-drilled holes on the front piece 6. Once attached,
tighten the cam locks (B) using a cross-head screwdriver and ensure the piece is secure.

34
5 6
7 8
E
DL
DR
E
E
DL
DR
E
K
K
K
K
K
K
Turn the drawer upside down.
Line up the holes on the outside pieces with the holes on
the runners (EDR & EDL),
secure to the drawer using screws (K).
1
A
A
A
A
Attach cam bolt (A) on piece1.
Attach the runners (E) to pieces 3 and 4 as
shown. Use screws (K).Put Caps (J) on the leg.
J
J
J
J
4
CR
E
3
CL
E
K
K
KK
K
2
4
F
F
G
G
Then attach pieces 2 to piece 4 using
screws (G) and wooden dowel (F).
Attach pieces 3 to piece2 & 4 using screws
(G) and wooden dowel (F).
Slot in piece 5 to the built-in ridges.
5
3
2
4
G
G
F
F
1
F
F
F
F
B
B
B
B
Attach the unit to Top panel 1 using
wooden dowels (F) and cam locks (B).

9
10
Turn the unit the right way up and insert the drawers.
Put the plastic corner support (H) on the backboard 5 using screws (I).
The unit should now be assembled and ready to use.
Ix4
Hx4