1. Select the type fixture you will control:
-Press repeatedly 3 times on button “Spot” to activate Fuze Spot Series
-Press repeatedly 3 times on button “Beam” to activate Beam Spot Series
-Press repeatedly 3 times on button “Wash” to activate Wash Spot Series
2. Press the button “Dimmer” to adjust brightness. Press directly on the button “+” or “-“ for desired settings.
3. Press the button “Strobe” to turn on/off the strobe effect. Press directly on the button “+” or “-“ for
desired settings.
4. Press the button ” ” to adjust the speed of sound program or adjust the sensitivity of sound control.
5. Press the button ” ” to adjust the speed of chase or adjust the sensitivity of voice control.
6. Press the button “1-9” to select one of the auto or sound activated programs.
7. Press the button “ ” to reset all.
8. Press the button “DMX” to select control via wired DMX signal.
Tips:
1. When activated RF function, the lamp will not control by DMX signal and the lamp is in the RF control
state. Each remote controller can only control a series of fixtures at the same time.
2. When Wash series opens “Dimmer” and “Strobe, it needs to press the number button to brighten the corresponding colour. In this mode, the
number button can only switch the colour wheel, but not the corresponding key colour for Spot and Beam series.
3. To turn off RF function, there are the following methods:
a. Select the signal input mode needed, “DMX’ can exit RF function.
b. Switch to other series of fixture “Spot”, “Beam”, “Wash”.
c. Press the menu button of the display panel.
