Bedding Products LS Hans Christian User manual

B ( 1 : 11 )
C ( 1 : 11 )
B
C
Step 1: Place the headboard against a stable wall. Then tighten the 10 M5x8 bolts about 2 mm into the connecting plates.
10 X
Step 2: Screw the legs into the metal corner piece and place the corner piece over the bolts in the headboard.
Do not fully tighten the bolts yet.
Step 3: Slightly tighten the M5x25mm bolts into the side and foot frames.
The bolts must always be inserted in the outer 3 holes of the frame.
18 X
Step 4: Hook the bolts of the side frame into the metal corner piece. Do not fully tighten the bolts yet.
Step 5: Attach the 2 remaining corner pieces to the foot end of the frames. Do not fully tighten the bolts yet.
Step 6: Hook the foot frame into the 2 corner pieces at the end of the side frames.
Push the frames downwards and tighten the bolts.

D ( 1/3.5 )
F ( 1/10 )
H ( 1/7 )
D
F
H
Step 7: Place the reinforcement plates in the corners, at the top of the frames. Make sure that the frames fit well and tighten the bolts.
2x 2x 4x
Step 8: Screw on the 4 support plates. The height is determined by the height of the slatted base.
78 -100mm
100 - 122mm
122 - 144mm
144 -166mm
166mm or higher
ASSEMBLY INSTRUCTIONS
Upholstered bed frame
"Hans Christian"
Step 9: Place the slatted bases and mattresses in the bed frame.
Version: November 2016