Behlen Country Magnum Painted Kennel User manual

F-
20557-6 TECHNICAL INFORMATION 70124 Rev. 4-24-17 12-12-07
Magnum Painted Kennel
CUSTOMER SERVICE CENTER
PO Box 569
Columbus, NE
68602-0569
Ph: 800-447-2751
Fax: [phone]
www.behlencountry.com
Hardware Kit
38900117
THANK YOU FOR PURCHASING THIS PRODUCT
Behlen Country has been in the business of providing quality equipment for more than 80
years. Our equipment will provide many years of service when maintained by the owner and
used in accordance with the capabilities of the product. For questions about this product, or
for parts inquiries, please contact our Customer Service Center listed below.
NOTE: Bottom of kennel has
1½” clearance to ground.
Do NOT install plugs in
bottoms of panels or door to
prevent holding water.
Typical Plug Installation.
Insert plugs in top (only) of
kennel panels and door at
circled locations as shown
at left.
Typical Dog Kennel Setup
The Latch comes installed
from the factory but may be
adjusted to any height by
loosening the nut, adjusting
to desired height and re-
tightening the nut.
TYPICAL CLAMP
SETUP
To attach panels,
one side of the
clamp will have
to be inserted
between the wire
and the vertical
tube before the
other side of the
clamp can be
attached. A clamp
should be attached
(as shown at left)
one at the top and
one at the bottom
of each panel.
LATCH COMPONENTS
Part No. Description Qty.
2208055 Latch, U-Clamp 1
2208056 Latch, Flipper 1
2688056 Nut 1
1328314 Bolt 1

F-19030-7 Rev. 4-24-17 4-1-99
4
7
5
2
3
1
6
Optional Powder Coat Wire Mesh Top for 5’ x 10’ Dog Kennel 38140017
Optional Powder Coat Wire Mesh Top for 10’ x 10’ Dog Kennel 38140027
Optional Hot-dipped Galv. Wire Mesh Top for 5’ x 10’ Dog Kennel 38140019
•For proper setup, have the wire facing the outside of the
kennel. For tops to fit properly, dog kennels must be set
up as shown.
•Each top panel will have to be attached by using the
butterfly clamps supplied.
•To attach the clamp, one side of the clamp will have to be
inserted between the wire and the vertical tube before the
other side of the clamp can be attached. A clamp should
be attached at each location shown in the diagram.
PARTS LISTING
ITEM DESCRIPTION PAINTED PLATED GALV. 10x10 QTY 5x10 QTY
1 Bolt, Carriage 3/8” x 1” ZP 1328327 12 4
2 1-5/8” Butterfly Connector 38600407 38600409 24 8
3 High Wing Nut 3/8” 2688306 12 4
4 Wire Mesh Top 38140017 38140019 2 (galv.) 1(painted)
4 Wire Mesh Top 38140027 1 (painted) --
5 10 x 10 Dog Kennel -- 1 --
6 Kennel Top Center Brace 38600397 38600399 1 --
7 5 x 10 Dog Kennel -- -- 1
NOTE: Wire Mesh Tops are an optional accessory and come in gray powder coat or hot-dipped galvanized.