Belkin RK5039 User manual

RK5039 Instructions Page 1 P35855
www.belkin.com
Belkin Corporation
501 West Walnut Street
Compton, CA 90220-5221, USA
Tel: [phone]; Fax: [phone]
©2005 Belkin Corporation. All rights reserved.
All trade names are registered trademarks of respective manufacturers listed.
RK5039 INSTRUCTIONS
RK5039 Product Inventory
1 - Power Strip Mounting Clip (3)
2 - Power Strip Mounting Bracket (3)
3- 10-32 Spring Nut (3)
4 - 10-32 x 3/4" Pan Head Screw (3)
5 - 10-32 x 1/2" Pan Head Screw (9)
6 - 10-32 Nut with Lock Washer (6)
7 - 10-32 x 3/8" Flat Head Screw (6)
8 - 10-32 x 1/4" Pan Head Screw (9)
Your Belkin RK5039 Power Strip Mounting Kit has been designed for 19" rack mount (0) Zero U
mounting. It will also mount Wiremold vertical power strips (Wiremold units using 1 1/2" narrow
aluminum housing). Enough hardware has been included to mount two rack mount PDU's
or one vertical power strip.
Instructions - (0) Zero U mounting
1. Install 10-32 spring nut by holding it horizontally in the slotted horizontal, pushing and turning it
clockwise into a vertical position. Repeat this step three times.
2. Install power strip mounting bracket using the 10-32 x 3/4" pan head screw.
3. Install PDU using
10-32 x 1/2" pan
head screw.
12 345
678
19" Rack Mount (0) Zero U Mounting

RK5039 Instructions Page 2 P35855
www.belkin.com
Belkin Corporation
501 West Walnut Street
Compton, CA 90220-5221, USA
Tel: [phone]; Fax: [phone]
©2005 Belkin Corporation. All rights reserved.
All trade names are registered trademarks of respective manufacturers listed.
Instructions - Vertical
Power Strips
1. Install 10-32 spring nut by holding
it horizontally in the slotted
horizontal, pushing and turning it
clockwise into a vertical position.
Repeat this step three times.
2. Install power strip mounting
bracket using the 10-32 x 3/4"
pan head screw.
3. Install power strip mounting clip
using the 10-32 x 3/8" flat head
screw.
4. Snap in your vertical power strip.
C
Note: Power strip mounting
brackets will also accept
Wiremold "Snap-on/Slide-off"
clips (included with Wiremold
power strips) used with 2"
housing.
Vertical Power Strip Facing Sideways
Vertical Power Strip Facing Back