Bellman & Symfon BE1260 User manual

Pager charger
Charging pins
Charger brackets
Charging LED
BE1270 bed shaker
2¯bed shaker jacks
Buttons and controls
In the box
BE1260 Pager charger with
pre-mounted backup batteries
External power supply
1
¯1.2 V NiHM rechargeable battery
intended for the pager
Supporting legs and screws + plugs
Charging LED
Green light: The pager is charging
No light: The pager is fully
charged or the power supply is not
connected to mains power.
Dimensions and weight
Height: 78 mm, 3"
Width: 88 mm, 3.5"
Depth: 43 mm, 1.7"
Weight: 385 g, 16.3 oz. incl. batteries
Accessories
BE1270 Bed shaker
Connects up to two bed shakers
BE9086 External trigger cable
Use output B
Power and battery
Mains power: 8 VDC / 800 mA
Battery power
4¯1.2 V NiMH rechargeable batteries
Note: The backup batteries must be
changed at a service center.
Pager charging time
Normal charging time: ~ 6 h
W. depleted backup batteries: ~ 24 h
Vibrator power: 2.0 – 4.0 VDC
Environment
For indoor use only
Technical specications
Warning! When using the pager charger ONLY USE RECHARGEABLE NiMH BATTERIES in the pager.
Non-rechargeable batteries will start to leak if the pager is placed in the charger and the battery acid will
damage the electronics. The resulting damage is not covered by warranty.
Supporting legs
BE1260

1 2 3
Getting started
1Important! Replace the old alkaline battery with the supplied 1.2 V NiHM rechargeable battery.
2Fit the supporting legs to the back of the charger and place it on a level surface. You can also mount it on the wall using
the supplied screws and plugs.
3Connect the power supply to the mains outlet and place the pager in the charger. The charging LED is green during
charging and goes out when the pager is fully charged. Connect the bed shaker and tuck it under the pillow or mattress.
If Try this
The pager doesn’t charge when it’s
placed in the charger
Check that the pager is positioned correctly in the charger. The charging LED
will light up in green to show that the pager is being charged.
If the charging LED doesn’t light up, the backup batteries may be depleted.
Connect the power supply to mains power and charge the backup batteries.
The bed shaker doesn’t vibrate when
the the pager is activated
Check that the bed shaker is connected correctly to the charger.
Check that the pager is positioned correctly in the charger. The charging LED
will light up in green to show that the pager is being charged.
If the charging LED doesn’t light up, the backup batteries may be depleted.
Connect the power supply to mains power and charge the backup batteries.
Testing the connection
Note: Charge the backup batteries for 24 hours before using it with a bed shaker.
1To test the radio link you need the pager and a Visit transmitter. Press the test button/s on the transmitter (see Testing
the connection for the relevant transmitter).
2If the pager is placed in the charger, it lights up a Visit LED and the bed shaker starts to vibrate.
If nothing happens, see Troubleshooting.
Troubleshooting
Most problems with the charger can be solved quickly by following the advice below.
Pager charger