Skyrc SK-100051 User manual

Thank you for your choice of the SKYRC eN, 100-240V AC, NiHM/NiCad fast charger. This unit is simple
to use but its operation does require some knowledge on the part of the user. Please read this entire
operating manual completely and attentively before using this product, as it covers a wide range of
information on operating and safety.
SKYRC eN NiMH/NiCad Charger is an economic, high quality 100-240V AC charger, designed for
charging NiMH and NiCad batteries from 4-8 cells. The circuit power is 50W and max charge current can
reach to 5A. There are four kinds of charge current 1A/2A/4A/5A that can be selected. You could select
the proper charge current according to battery capacity.
INSTRUCTION MANUAL
INTRODUCTION
CHARGE PROCEDURES
SKYRC eN comes with the built in power supply. You can connect the AC power cord to the AC socket
(100-240V AC) directly.
Insert the AC power cord into the charger.
Insert the AC cord into a wall socket (100-240V). The charge status LED will light for 1 second and
then flash green which indicates the charger is ready for charging.
Select the proper charging current 1A/2A/4A/5A by the toggle switch. Generally, batteries with a
capacity of 2500mAh and above can be charged at 5 amps.
Connect battery lead to charger’s battery socket.
The charger starts charging. The charge status LED will glow constant red.
When the battery is fully charged, the charge status LED will glow constant green.
Unplug the battery from the charger and the charge status LED will flash green which indicates the
charger is ready to charge another battery.
Please refer to following steps to charge the battery,
1)
2)
3)
4)
5)
6)
7)
EXPLANATION OF LED STATUS
The charge current can’t be changed during charging process. If you change it, the charge status LED will
flash red to alert you to the error. In this case, please disconnect the power cord from the wall socket and
unplug the battery from the charger. You need to restart the charger to make it work again.
* Error Message
- 1 - - 2 -
SPECIFICATION
AC Input
Battery Type
Cell Count
Charge Current
Circuit Power
Dimension
Weight
Charger/Cell Status
100-240V
NiMH/NiCad
4-8 cells
1A/2A/4A/5A ± 10%
50W
82.7x140.5x45.7mm
305g
SK-100051
Battery Socket Charge Current Switch
Charge Status LED Indicator
AC 100-240V
Power Jack
Capacity
1000mAh
3000mAh
3000mAh
Charge Current
1A
2A
5A
Approximate Charge Time
60 mins.
90 mins.
36 mins.
How to calculate the charge time?
Charge Time (mins) =Battery Capacity (Ah)/Charge Current (A)
CHARGE LED STATUS
LED Flashes Green
LED Glows Red
LED Glows Green
CHARGE STATUS
The Charger is Ready to Charge
The Charger is Charging
The Charger Finished Charging Process
CONNECTION DIAGRAM
Charger
NiMH Battery
This diagram shows the
correct way to connect
your battery to the eN
charger while charging.
Failure to connect as
shown in this diagram will
damage this charger.
CAUTION:

7504-0253-02
Manufactured by
SKYRC TECHNOLOGY CO., LTD.
www.skyrc.com
- 3 - - 4 -
THE SET CONTAINS WARNING AND SAFETY NOTES
SKYRC eN is suitable for charging rechargeable NiMH/NiCd batteries. Do not attempt to recharge dry
cells. Charging other types of batteries may cause fire or explosion.
Never leave the charger unattended when it is connected to its power supply.
The allowable AC input voltage is 100-240V AC. Never connect it to any other voltage.
Protect charger from dust, dirt and damp.
Never place the charger and batteries connected to it on any form of flammable surface. Never
operate the charger in the vicinity of inflammable material or gas.
Ensure that there is an unrestricted airflow to and from the charger's cooling slots. Never place the
charger on a carpet or similar surface.
Take great care to maintain correct battery polarity, and avoid shot-circuit. Read the battery
manufacturer's instructions and adhere to them strictly.
WARRANTY AND SERVICE
We guarantee this product to be free of manufacturing and assembly defects for a period of one year
from the time of purchase. The warranty only applies to material or operational defects, which are present
at t he time of purchase. During that period, we will repair or replace free of service charge for products
deemed defective due to those causes.
You will be required to produce proof of purchase (invoice or receipt). This warranty is not valid for any
damage or subsequent damage arising as a result of misuse, modification or as a result of failure to
observe the procedures outlined in this manual.
LIABILITY EXCLUSION
This charger is designed and approved exclusively for use with the types of battery stated in these
Instruction Manual. SKYRC accepts no liability of any kind if the charger is used for any purpose other
than that stated. We are unable to ensure that you follow the instructions supplied with the charger, and
we have no control over the methods you employ for using, operating and maintaining the device. For this
reason we are obliged to deny all liability for loss, damage or costs which are incurred due to the
incompetent or incorrect use and operation of our products, or which are connected with such operation
in any way. Unless otherwise prescribed by law, our obligation to pay compensation, regardless of the
legal argument employed, is limited to the invoice value of those SKYRC products which were
immediately and directly involved in the event in which the damage occurred.
RECOMMENDED ACCESSORIES
SkyRC eN Charger
AC Power Cord
18AWG Wire Charging Cable
Tamiya charging cable
5201-0030-01
TRAXXAS charging cable
5201-0033-01
Glow charging cable EC3 charging cable
5201-0045-01 5201-0034-01
Crocodile clip
charging cable
5201-0031-01
Dean charging cable
5201-0012-01
Futaba RX charging cable
JST/BEC charging cable
5201-0044-015201-0043-01
CONFORMITY DECLARATION
SKYRC eN satisfies all relevant and mandatory EC directives and FCC Part 15 Subpart B: 2008.
The product has been tested to meet the following technical standards:
This symbol means that you must dispose of electrical devices from the general household
waste when it reaches the end of its useful life. Take your charger to your local waste
collection point or recycling centre. This applies to all countries of the European Union, and to
other European countries with a separate waste collection system.
Conform
Conform
Conform
CE-EMC
FCC-VOC FCC Part 15B
Electromagnetic compatibility (EMC) -- Part 6-3:
Genericstandards - Emission standard for residential,
commercial andlight-industrial environments.
Electromagnetic compatibility (EMC) -- Part 6-1: Generic
standards - Immunity for residential, commercial and
light-industrial environments.
EN61000-6-1
EN61000-6-3
Test Standards Title Result
Electromagnetic compatibility (EMC), Conduction Emission
& Radiation Emission.
Conform
EN61000-3-3
Electromagnetic compatibility (EMC) - Part 3-3: Limits -
Limitation of voltage changes, voltage fluctuations and
flicker in public low-voltage supply systems, for
equipment with rated current 16 A per phase and not
subject to conditional connection.
EN61000-3-2
Electromagnetic compatibility (EMC) –
Part 3-2: Limits – Limits for harmonic current emissions
(equipment input current ≤16 A per phase)
Conform
EN60335-2-29
CE-LVD
Household and similar electrical appliances –. Safety –.
Part 2-29: Particular requirements for battery chargers.
Conform