Belson Outdoors RPP22 User manual

Model # RPP22 Instructions Sheet
www.belson.com
SQUARE RECYCLED PLASTIC PLANTER
627 Amersale Drive
Naperville, IL 60563
Phone: [phone]
Fax: [phone]
[email protected]

FP - FASTENER PACK
( 1 ) - ONE FASTENER PACK
( 1 ) - ONE BOTTOM PLATE
B - FRAME RING
( 2 ) - TWO FRAME RINGS
( 4 ) FOUR SIDE PANELS
www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED.

www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED.
16 - #12 X 2 1/2” PAN HEAD PHILLIPS SCREW
ALSO NEED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS:
1 - #3 PHILLIPS DRIVE BIT

www.belson.com
STEP #1:
AS SHOWN IN THE DIAGRAM ABOVE, PLACE ON SIDE PANEL FACE DOWN ON A FLAT SURFACE. PLACE THE
FRAME RINGS AT THE TOP AND BOTTOM SECTIONS OF THE PANEL BEING SURE TO LINE UP THE
PRE-DRILLED PILOT HOLES IN THE SIDE PANEL. USE THE DIAGRAM ABOVE FOR PLACEMENT. FASTEN USING
( 1 ) ONE 2-1/2” PAN HEAD SCREWS PER HOLE.
#12 X 2 1/2” PAN HEAD
PHILLIPS SCREW

#12 X 2 1/2” PAN HEAD
PHILLIPS SCREW
www.belson.com
STEP #2:
PLACE ANOTHER SIDE PANEL BESIDE THE PREVIOUS PANEL SO THAT IT TOUCHES AS DISPLAYED IN THE
DIAGRAM ABOVE. GENTLY TURN THE SIDE PANEL WITH THE RINGS INSTALLED ON TO THE NEW SIDE PANEL.
MAKING SURE THE HOLES LINE UP WITH THE PRE-DRILLED PILOT HOLES IN THE NEW PANEL. FASTEN
USING ( 1 ) ONE 2-1/2” PAN HEAD SCREW PER HOLE.

#12 X 2 1/2” PAN HEAD
PHILLIPS SCREW
www.belson.com
STEP #3:
REPEAT STEP #2.

www.belson.com
STEP #4:
PLACE THE BOTTOM PANEL INTO THE OPENING BETWEEN THE FRAME RINGS.

www.belson.com
#12 X 2 1/2” PAN HEAD
PHILLIPS SCREW
STEP #5:
REPEAT STEP #2.

www.belson.com
STEP #6:
TURN THE PLANTER UPRIGHT ONTO ITS BASE. PLEASE USE CAUTION WHILE MOVING AS THIS
PLANTER WILL WEIGH APPROXIMATELY 96 POUNDS.