BENDHEIM QuicKISS User manual

QuicKISS Magnetic Dry-Erase Glass Boards
INSTALLATION INSTRUCTIONS
TOOLS REQUIRED
•Drill/Screw Gun
•1/8” Drill Bit
•Level
•Tape Measure
•Pencil
•Safety Gloves
•Safety Goggles
•Jigsaw
HARDWARE PROVIDED
Hardware Bag Contains:
•(6) 2” #12 Drywall-to-Wood Screws
•(6) 2” #12 Drywall-to-Metal Self-Drilling Screws
•(1) Wall Bracket
•Velcro Wall Protectors
Note: (1) hardware bag is provided for 2’x3’ and 3’x4’
boards; (2) hardware bags are provided for 4’x6’ and
4’x8’ boards
INSTALLATION INSTRUCTIONS
1. Measure down 5/16” from the top of the desired location of the board.
2. Draw a Level line to align the top edge of the Wall Bracket.
Note: For portrait installation, wall bracket must be cut. See Table 1 on next page for
bracket length.
3. Align holes in Wall Bracket with wall studs. Pre-drill holes into wall studs.
Note: See Table 2on next page for minimum anchor points needed for each board.
4. Install Wall Bracket into building structure or wall studs (wood or metal) (Fig. A).
5. Ensure screws are flush with the face of the wall bracket to prevent scratching.
6. Mount the board on to Wall Bracket (Fig. B & C).
7. Adhere Velcro Wall Protectors on the bottom hem of the board.
8. Confirm the board is securely hung on the Wall Bracket.
Fig. A
Fig. B
Fig. C
Please visit https://www.youtube.com/watch?v=9eNtR24d794 for an installation video.

QuicKISS Magnetic Dry-Erase Glass Boards
INSTALLATION INSTRUCTIONS (CONT.)
Portrait Installation Wall Bracket Length
2’ x 3’ Board 3’ x 4’ Board 4’ x 6’ Board 4’ x 8’ Board
Cut to 20” Cut to 32” Cut to 44” Cut to 44”
Table 1: Wall bracket lengths required to install each board in portrait orientation
Minimum Structural Studs Required for Support
2’ x 3’ Board 3’ x 4’ Board 4’ x 6’ Board 4’ x 8’ Board
Landscape Orientation
2
3
4
5
Portrait Orientation 2 2 3 3
Table 2: Minimum structural studs required for support for each size board
MAINTENANCE & CARE
COMPATIBLE MARKERS & ACCESSORIES
A variety of markers are compatible with Bendheim glass marker boards, including:
•Dry-erase markers
•Wet-erase markers (neon pens, liquid chalk, etc.)
•Permanent markers
Ultra-strong rare-earth magnets are recommended for best results. Magnetic
accessories, including magnets, erasers, and marker trays, are available from
Bendheim.
CLEANING THE BOARD
Bendheim glass marker boards are easy to maintain:
•Dry-erase marker can be removed with any standard dry-erase eraser
•Wet-erase marker can be removed using water or conventional glass cleaner
and lint-free cloth (terry cloth)
•Permanent marker can be removed using conventional glass cleaner and a lint-
free cloth
Additionally, it is recommended to occasionally clean the glass surface with warm
water or conventional glass cleaner and a lint-free cloth to keep the board looking
new.