Best-Rite Black Splash User manual

Best-Rite 4' x 8' Black Splash-
Cork Bulletin Board with Ultra Trim
Instruction Manual

1Locate and Drill holes
for Z-Hangers. 2Attach Z-Hangers
for mounting. 3Hang board and mark bottom 4Remove board and drill
5Attach Lower Brackets and
Hang board 6Secure Board
Determine board location. Measure from floor to
the top edge of board. Mark with pencil line the
corner location. Measure down from top edge of
board 1-5/8”, and draw line as shown. Locate
stud near each end of board and drill pilot hole
along line using 1/16” drill bit.
Hang board on
the Z-Hangers
using the Hanging
brackets mounted
on the back of the
board.
Draw line along
bottom edge of
board.
Secure board to bottom
brackets using 2 short
screws as shown.
Attach 2 Z-Hangers using 2 Long Screws as shown
Board Location
Board Location
1 5
8
Top Edge
of Board
Wall Stud
Draw line
Hanging Brackets on
back of board
11
8
Lift and remove board from the Z-Hangers.
Measure up from bottom line of board 1-1/8”, and
draw line as shown. Locate stud near each end of
board and drill pilot hole along line using 1/16” drill
bit.
Draw line
Board Location
Bottom Edge
of Board
Drill Hole
Secure 2 bottom brackets to the wall using 2 long
screws as shown.
Hang board on the Z-Hangers using the Hanging
brackets mounted on the back of the board.
P1 Board 1 EA
Parts List
Should you require assistance during
assembly, please call our Customer Service
Department
Monday - Friday 8 a.m. - 5 p.m. Central
Standard Time
Toll-Free Customer Service
1-800-749-2258
E300Px-T1_03/26/10
SPLASH CORK
E300Px-T1 Tackboard
Hardware List
A Z Hanging Bracket 2 EA
B Bottom Bracket 2 EA
C Long Screw 4 EA
D Short Screw 2 EA
E Screw Anchor-Concrete 4 EA
F Screw Anchor-Drywall 4 EA