Bergstrom NITE User manual

Bergstrom, Inc. 2390 Blackhawk Road ●P.O. Box 6007 ●Rockford, IL 61125 ●www.nitesystem.com ●1-866-204-8570
Before You Start
1
ATTENTION:
This model truck requires the blower orientation
to be changed before installation.
Please follow the following steps to change the
blower orientation from side discharge to top
discharge. You may also reverse these directions
to change the orientation from top to side.
Remove Screws
From Top Cover
Remove all the screws
that are holding the top
cover in place. Also
remove the small cover
plate that is attached to
the center of the cover.
This small plate will be
used in step #13.
1

Before You Start
2
Remove Two Screws from
the Back Panel
Removal of these screws will
provide the additional clearance
needed to remove the blower.
2
Flip Top Cover Up and
Lean it Against the Back
Leaving Wires Attached.
3
Unplug the Blower
Motor Power Wires
4

Before You Start
3
Remove the 2 Phillips
Head Screws from the
Front Panel Under the
Air Outlet
6
Remove the Blower
From the Unit
7
Remove the 2 Screws
from the Side Panel
that Attach the Blower
Mounting Plate
5

Before You Start
4
The Mounting Plate Must be
Removed and Turned Around
8
Place the Blower Back
Into the Unit With the
Discharge Facing Up
9
Reinstall Blower Support
Bracket Screws
Because the blower has been
rotated, the screws removed in
step #5 now need to be reinserted
into the new holes indicated in
the photo.
10

Before You Start
5
Reattach the Cover
Put cover back on the NITE unit and
reinsert and tighten all screws
except for the 4 screws that attached
the small cover plate. Also, since the
blower has been rotated, the two
screws removed in step #6 should
now be inserted in the top cover as
indicated in photo.
12
Attach Small Cover Plate Over
Old Air Outlet on Side Panel
Remove the four screws surrounding
the opening on the side panel and use
them to install the small cover plate
that was removed from the top cover
in step #1.
13
Reconnect the Wires
You Disconnected in
Step #4
11